Bedienungsanleitung Einhell GE-EM 1536 HW (Seite 26 von 114) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch, Schwedisch)

546966

Zoom out

Zoom in

Vorherige Seite

1/114

Nächste Seite

- 26 -

Adjusting the cutting height

Important!

Adjust the cutting height only when the motor is

switched oﬀ and the power cable has been dis-

connected.

Before you begin to mow, check to ensure that the

blade is not blunt and that none of the fasteners

are damaged. To prevent any imbalance, replace

blunt and/or damaged blades. To carry out this

check, ﬁ rst switch oﬀ the motor and pull out the

power plug.

The cutting height is adjusted as follows

(see Fig. 15):

1. Push the lever (A) outwards.

2. Set the lever (B) to the desired cutting height.

3. Release the lever (A) and check that it is se-

curely seated in the lock.

Reading oﬀ the cutting height

The cutting height can be set between 25-75 mm

in 6 intervals, and can be read oﬀ on the scale

(Fig. 15/C).

Power supply

The lawn mower can be connected to any light

socket-outlet with a 230 Volt alternating current.

However, the socket outlet must have an earthing

contact protected by a 16 A circuit breaker. Addi-

tionally, a residual current device (RCD) circuit-

breaker with max. 30 mA must be used!

Power cable for the device

Please only use power cables that are not dama-

ged. The total length of the power cable should

not exceed 50 meters; going beyond this distance

will reduce the power output of the electric motor.

The power cable must have a cross-section of 3

x 1.5 mm. The insulating sheath of lawn aerator

power cables is frequently damaged.

Some of the causes for this are:

•

Cuts caused by driving over the cable.

•

Pinching when the power cable is dragged

under doors and pulled through windows.

•

Cracking due to old age of the insulation.

•

Kinking by improperly fastening or guiding the

power cable.

The power cables must, at the very minimum, be

of type HO5RN-F and 3-stranded. The cable type

must be printed somewhere on the power cable.

Only purchase power cables that are marked!

Plugs and socket couplers for the power cables

must be made from rubber and splash-proof.

There is a limit to how long power cables can be.

Longer power cables require larger conductor

cross-sections. Power cables and connecting li-

nes must be regularly checked for damage. Ensu-

re that the lines are switched oﬀ before checking

them. Completely unwind the power cable. Also

check power cable entry points, plugs and socket

couplers for kinks.

6. Operation

Connect the plug (Fig. 1/Item 8) to an extension

cable. It is imperative to secure the extension

cable with the cable grip as shown in Figure 16.

Important!

To prevent the equipment switching on acciden-

tally, the lawn mower is equipped with a safety

switch (Fig. 16/Item 1) which must be pressed be-

fore the switching bar (Fig. 16/Item 2) can be ac-

tivated. The lawn mower switches itself oﬀ when

the switching bar is released. Repeat this process

several times so that you are sure that the ma-

chine functions properly. Before you perform any

repair or maintenance work on the equipment,

ensure that the blade is not rotating and that the

power supply is disconnected.

Important!

Never open the discharge ﬂ ap if the grass

box is being emptied and the motor is still

running. The rotating blade can cause seri-

ous injuries.

Always secure the discharge ﬂ ap and grass bag

carefully. Always switch oﬀ the motor before you

remove these items.

The safety distance between the blade casing

and the user provided by the guide struts must be

maintained at all times. Take special care when

mowing and changing direction on embankments

and slopes. Ensure that you have a secure sur-

face to stand on, wear shoes with anti-slip soles

that oﬀ er good grip, and long trousers.

Always mow across the slope (not in up or down

direction). Do not use the mower on gradients

exceeding 15° for safety reasons.

Take special care when moving backwards and

pulling the lawn mower. Danger of stumbling.

Anl_GE_EM_1536_HW_M_SPK7.indb 26Anl_GE_EM_1536_HW_M_SPK7.indb 26 31.07.13 15:4831.07.13 15:48

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Einhell GE-EM 1536 HW Seite 26

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info