724140
23
Zoom out
Zoom in
Vorherige Seite
1/88
Nächste Seite
GB
- 23 -
When the sleep function has been activated, the
fan will automatically run at low speed. The fan
speed cannot be changed.
5.8 Remote control
All modes and functions can be set using the
supplied remote control.
Use two alkali batteries, type R03 AAA (1.5 V)
(not supplied).
Never use a combination of new and used
batteries.
Never use a battery type other than the spe-
cified one.
If the remote control is not used for a lengthy
period of time, remove the batteries to pre-
vent them leaking.
Dispose of spent batteries properly.
Point the remote control towards the air-con-
ditioning system. The range is max. 5 meters.
Direct sunlight and objects can considerably
reduce the range of the remote control.
Handle the remote control with care. Do not
drop it and keep it away from heat and mois-
ture.
Inserting batteries
1. Open the battery compartment cover.
2. Insert two new batteries. Be sure to observe
the correct polarity (+/-) of the batteries.
3.
Close the battery compartment cover.
5.9 SETTING THE AIR FLOW DIRECTION
The vertical direction of the air flow is determined
by the vertical ventilation grille. It has to be
adjusted by hand.
The horizontal direction of the air flow is
determined by the horizontal ventilation grille. It
has to be adjusted by hand.
5.10 Draining the condensate in the
condensate tray (Fig. 8)
For the cooling mode the device is fitted with
a condensate return unit. When the system is
in operation the condensate is collected in a
trough (approx. contents 0.85 liters) integrated
in the device. From there it is evaporated by the
condenser and transferred outside by the exhaust
air hose.
Note:
If the humidity in the room exceeds 85% (RH), a
condensate drainage hose (see section “5.11”) is
absolutely essential.
ALL OF THE CONDENSATE MUST BE
DRAINED OFF BEFORE YOU EVER
RELOCATE OR STOP USING THE DEVICE.
Note:
When the condensate tray is full the compressor
and the fan motor shut down. The “F.W.” LED
flashes and a signal sounds. The signal can be
disabled by pressing any button. The unit will
then be shut down completely.
When this happens, empty the tray as described
below:
1.
Switch off the unit, pull the plug and do not
move the unit.
2.
Push a container under the drain screw (1).
3. Unscrew the drain screw (1).
4. Remove the rubber bung (2) from the drain
opening (3).
5.
The condensate runs into the container. If the
container is smaller than the condensate tray,
seal the drain opening (3) with the rubber
bung (2) and empty the container. Then
repeat the process from point 4.
6.
Once the condensate tray has been
completely emptied, fit the bung (2) and the
drainage screw (1) again.
7. Start the unit again. The “F.W.” LED will no
longer flash.
5.11 Draining the condensate with a hose
(Fig. 8-10)
ALL THE CONDENSATE MUST HAVE
BEEN DRAINED BEFORE YOU START THE
FOLLOWING PROCESS.
1.
Switch off the unit and pull the power plug.
2. Unscrew the drain screw (1).
3. Remove the rubber bung (2) from the drain
opening (3).
4. Connect the condensate drainage hose (4)
and secure it with a clip
5. The drainage hose can be extended with a
hose (5) with a diameter of 18mm. If you do
so, make sure you use a suitable connector.
Note:
The drainage hose must run to the outside with a
slight fall. The “Condensate tray full” indicator is
not operational.
Anleitung_MK_2100_E_SPK7.indb 23Anleitung_MK_2100_E_SPK7.indb 23 25.09.2018 10:12:4125.09.2018 10:12:41
23

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Einhell MK 2300E wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info