Bedienungsanleitung Electrolux EFP 6430 (Seite 41 von 72) (Deutsch, Englisch, Holländisch, Französisch, Portugiesisch, Spanisch)

451825

Zoom out

Zoom in

Vorherige Seite

1/72

Nächste Seite

Control Panel -

EFP 6410

 Best results are obtained by using a low speed for normal conditions and a high speed when odours are more

concentrated.

Turn the hood on a few minutes before you start cooking, you will then get an under pressure in the kitchen.

The hood should be left on after cooking for about 15 minutes or until all the odours have disappeared. The

control switches are located on the units front panel:

Control device for grease and

charcoal filters

This hood is fitted with a device that signals when it

is necessary to clean the grease filter or the

charcoal filter (in the case of recirculation version

with charcoal filter).

On delivery, the hood is not supplied with an

charcoal filter, so the saturation indicator will be

disabled.

If the hood is to be used with a charcoal filter, the

saturation

indicator light must be enabled as follows:

Press buttons B and G simultaneously and hold

them for 3 seconds. At first only the grease filter

LED D will light up, but when the charcoal filter

LED E lights up the saturation indicator will be

enabled.

To disable it: Press buttons B and G again

simultaneously and hold

them for 3 seconds, until the charcoal filter LED

goes out.

Grease filter LED (D)

LED D will start to flash when it is time to clean

the grease filter.

Cleaning will be necessary after 40 working hours.

Always comply with the maintenance instructions

for the grease filter.

Charcoal filter LED (E)

The charcoal filter LED E will start to flash when

the charcoal filter needs to be replaced.

This operation is necessary after approximately

160 working hours.

Correct ventilation

If the cooker hood is to work correctly there must

be an under pressure in the kitchen. It is important

to keep the kitchen windows closed and have a

window in an adjacent room open.

The extractor part (visor) of the hood is used to

switch the fan on and off when the appliance is

switched on (Motor).

When the visor of the appliance is withdrawn, the

fan automatically switches on.

If the visor is pushed in without operating the

switches, the fan is switched off.

The lighting can be separately switched on and off

with the slide switch.

Should the hood or the controls fail to operate:

disconnect the power supply for at least 5 seconds,

then turn the hood back on again.

A - Main switch, hood off.

B - Start and choice of motor speed 1-2-3-1-

2.........

C - Indicates speed 1 (LED).

D - Indicates speed 2 and saturation of the

grease filter (LED)

E - Indicates speed 3 and saturation of the

charcoal filter (LED) (flashing LED)

F - Indicates Intensive speed (LED).

G - Intensive speed on/off. The Intensive

speed runs for 5 minutes:

If the hood is on when the Intensive speed

is activated, the hood reverts to previous

speed after 5 minutes.

If the hood is off when the Intensive

speed is activated, the hood will be turned

off after 5 minutes.

To interrupt the Intensive speed, press

button A or B.

H - Light OFF

I - Light ON

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Electrolux EFP 6430 Seite 41

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info