Bedienungsanleitung Electrolux EFP 6430 (Seite 43 von 72) (Deutsch, Englisch, Holländisch, Französisch, Portugiesisch, Spanisch)

451825

Zoom out

Zoom in

Vorherige Seite

1/72

Nächste Seite

Charcoal filter

 The charcoal filter should only be used if you

want to use the hood in the recirculation

function.

 To do this you will need an original

ELECTROLUX charcoal filter (available from

your local Service Force Centre).

 Replacing the charcoal filter

E-Nr. 610 899 421

The charcoal filter must normally be replaced at

least once every year. This filter cannot be

washed or regenerated.

To guarantee proper absorption of odours the

working volume of the charcoal must be

proportionate to the hood air flow. In this case

the high quality of the charcoal will ensure

efficient odour removal for approximately one

year, assuming that the hood is used normally.

For this reason you should always use original

AEG filters only, making sure they are replaced

when necessary.

 Mounting

1. Pull out the vapour catcher (Fig. 1 - A).

2. Remove first the rear then the front grease

filters.

3. Insert the charcoal filter into the lugs of the

holding frame above using the 2 red clips to

retain it below, press the red clips inwards, and

insert the charcoal filter in the holding frame.

Fig. 4.

 Dismounting:

1. Press both red lugs upwards (towards the

inside of the housing) and remove the charcoal

filter downwards.

2. Clean the internal housing only with warm

washing-up liquid suds (never use any abrasive

cleaners, brushes, or scouring agents).

 Always specify the hood model code number

and serial number when ordering replacement

filters. This information is shown on the

registration plate located on the inside of the

unit.

 The charcoal filter can be ordered from your

local ELECTROLUX Service Force Centre.

Changing the light bulb(s)

 Disconnect the unit from the mains power

supply.

 Pull out the drawer.

 Open the lamp cover support.

 Replace the old light bulb with a new light bulb

of the same kind.

 Replace the lamp cover support.

 If the light does not come on, make sure the

bulb has been screwed in correctly before

contacting the technical assistance service.

Fig. 4

 Cleaning/replacing the charcoal filter

E-Nr. 942 120 399

Unlike other charcoal filters, the LONGLIFE

charcoal filter can be cleaned and reactivated.

At normal use the filter should be cleaned every

second month (when using the hood 2,5 hours

per day, in avarage). The best way to clean the

filter is in the dishwasher. Use normal detergent

and choose the highest temperature (65º C).

Wash the filter separately so that no food parts

gets stuck on the filter and later causes bad

odours. To reactivate the carbon, the filter

should be dried in an oven for 10 minutes with a

temperature of maximum 100º C.

After approximately three years of use, the

charcoal filter should be replaced with a new, as

the odour reduction capacity will be reduced.

Fig. 5

CLOSED

OPEN

CLOSED

OPEN

EFP 6430

EFP 6410

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Electrolux EFP 6430 Seite 43

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info