SETTING DECSRIPTION FOR GSM MODULE GST1
FOR CORRECT COMMISSIONING, THE FOLLOWING PROCEDURE MUST BE OBSERVED!
1. Install and set the thermostat according to the instructions
2. Constants 11, 12 and 13 must be set on the thermostat as follows:
PHONE NUMBER SETTING – CONST 12
The phone number to which SMS messages about the thermostat status
should be sent must be entered in the international format (0420123456789).
(Enter the phone number to which all feedback reports should be sent.)
Set with the buttons and confirm with the .
You can browse the preset numbers by means of .
+/- H
+/- T i
SETTING THE PIN CODE OF THE SIM CARD USED – CONST 13
Set the PIN code of the SIM card inserted in the GST1 module.
Set with the buttons and confirm with the .
You can browse the preset numbers by means of .
+/- H
+/- T i
Thanks to this function, you do not have to remember the PIN code of the phone
card inserted in the module connected to the thermostat.
3. Insert an activated SIM card in the GST1 module. The SIM card holder is located in the rear part, once
you open the cover at the arrow (see page 2).
4. Connect the thermostat to the GST1 module by means of the (enclosed) data cable; then connect the
module to the 230 V / 50 Hz mains via the supply unit!
12
5. After orange LED start lit, push the button on the thermostat to test correct connection.
One of the following messages appears on the thermostat display:
Test
Indicating correct connection of the module Indicating correct connection of the module and
PIN code setting
Module not connected, bad connection of the
module!
Indicating correct connection of the module, but
bad PIN code setting! You must disconnect the
module, RESET the thermostat and enter the
correct PIN code!
CONTROL OPTION BY MEANS OF THE GSM MODULE – CONST 11
Choose the GSM: A option with the buttons and confirm with the .
+/- T i
