Bedienungsanleitung Elica Ye (Seite 27 von 136) (Alle Sprachen)

649836

Zoom out

Zoom in

Vorherige Seite

1/136

Nächste Seite

Operation

Use the high suction speed in cases of concentrated kitchen

vapours. It is recommended that the cooker hood suction is

switched on for 5 minutes prior to cooking and to leave in

operation during cooking and for another 15 minutes

approximately after terminating cooking.

Note: if the hood does not work, make sure that it is ON by

using the ON/OFF button.

The button is inside the hood and can be reached by

removing the grease filter.

Fig. 19

Using the remote control

The remote control is able to control all the functions of the

hood:

Select the suction speed (power)

Light ON/OFF

Not implemented

Selecting the suction speed (power):

Press the "◄" key or the "►" key until you see the symbol

relating to the “Select the suction speed (power)” function.

Press the “+” key or the “-” key or the "■" key respectively to

increase or diminish or switch off (stand-by) the speed

(suction power).

Light ON/OFF:

Press the "◄" or "►" button, until the LED corresponding to

the "Light ON/OFF" symbol appears on the remote control.

Press the “+” or “-” button to put on or off the lights.

Press the "■" to change the status of the lights, from off (all

lights) to on (all lights) and vice-versa.

Configuration of the remote control

To enable the remote control, proceed as follows:

Press the "◄" or "►" button until you can see on the remote

control the symbol "

" related to the function “Reset and

configuration of the filter saturation signalling” and press

continuously on the central button "■" for at least 5 seconds.

An audible signal indicates the successful configuration.

Maintenance of the remote control

Cleaning the remote control:

Clean the remote control with a damp cloth and a neutral

solution of detergent without abrasive substances.

Changing the battery:

• Open the battery casing using a small screwdriver with a

flat point.

• Change the finished battery with a new one of 12 V type

MN21/23

In inserting the new battery respect the polarity indicated

on the battery casing!

• Close the battery casing up again.

Disposal of the batteries

Ultimate disposal of the batteries should be handled according

to all national laws and regulations. Do not place used

batteries in your regular waste.

Ultimate disposal of the batteries must be done safely.

Contact your local waste management officials for other

information regarding the environmentally sound collection,

recycling, and disposal of the batteries.

Maintenance

ATTENTION! Before performing any maintenance operation,

isolate the hood from the electrical supply by switching off at

the connector and removing the connector fuse.

Or if the appliance has been connected through a plug and

socket, then the plug must be removed from the socket.

Cleaning

The cooker hood should be cleaned regularly (at least with the

same frequency with which you carry out maintenance of the

fat filters) internally and externally. Clean using the cloth

dampened with neutral liquid detergent. Do not use abrasive

products. DO NOT USE ALCOHOL!

WARNING: Failure to carry out the basic cleaning

recommendations of the cooker hood and replacement of the

filters may cause fire risks.

Therefore, we recommend observing these instructions.

The manufacturer declines all responsibility for any damage to

the motor or any fire damage linked to inappropriate

maintenance or failure to observe the above safety

recommendations.

The hood should be cleaned regularly (at least with the same

frequency with which you perform the maintenance of the

grease filters) internally and externally.

The chimney and the body of the hood are produced in

CRISTALPLANT

Note: For more details on the material CRISTALPLANT

and

the Manufacturer, visit www.cristalplant.it

Maintenance of CRISTALPLANT

DAILY CARE

CRISTALPLANT

requires an easy and quick daily care.

It is enough to clea CRISTALPLANT

using soap and

water or common detergents to remove most of the dirt

and stains that may be deposited on the surface. It is

particularly recommended to rinse the surface well and to

use gel or abrasive detergents with abrasive sponges like

the original matt finish, distinguishing feature of

CRISTALPLANT

, will keep untouched.

HOW TO PREVENT FROM DAMAGES

The surface is generally strongly resistant against stains

and spots; nonetheless aggressive chemical products,

such as acetone, trichloroethylene, strong acids or bases

are not recommended. After long contact periods, several

substances like ink, cosmetics and dyes, may leave

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Elica Ye Seite 27

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info