Bedienungsanleitung Elite EPC-807 Platinum (Seite 4 von 15) (Englisch)

589906

Zoom out

Zoom in

Vorherige Seite

1/15

Nächste Seite

BEFORE FIRST USE .

Working

Pressure

PSI Maximum

Pressure

Keep Warm

Temperature

Preset Timer

0~70kPa 12 PSI 90kPa

140ºF ~ 175 ºF

1~9 Hours

1. Remove packaging materials such as cardboard, plastics or Styrofoam and discard

appropriately.

2. Clean all the parts by wiping with a soft damp cloth or sponge and dry thoroughly.

LID ASSEMBLY

1. How to open the lid: When the lid (2) of the cooker is at the Closed position (Figure 1),

hold the Handle (1) and turn it clockwise until you reach the Opened-Lid position

(Figure 2). Lift up and the lid will swing open vertically.

Note: For new units, the seal of the lid may be slightly stronger than normal and may be

slightly difficult to unlock. Once the lid has been opened and closed several times, it will

loosen up.

2. How to close the lid: When the Lid (2) of the cooker is in vertical position (Figure 4),

hold the Handle (1) and close it downwards at the Opened Lid position (Figure 5). Turn

counter-clockwise until you reach the Closed Lid position. (Figure 6).

3. How to dismantle the lid: When the lid (2) of the cooker is in the upright vertical position

(Figure 7), hold the lid with both hands, and adjust the height between the Lid and the

upper edge of the cooker to approximately 10cm (Figure 8). Then turn it counter-

clockwise until you reach the Closed Lid position (Figure 9). In order to remove the lid,

you will need to move in an upward direction (Figure 10).

4. How to install the lid: Hold the Lid (2) with both hands at the Closed Lid position and

pull it upwards in a slanted position which leads to a height of 10cm between the Lid and

the upper edge of the cooker (Figure 11). Align the Lid’s Sliding Valve (7) to the pressure

cooker’s Lock-Slider (6) and turn it in a clockwise direction until you reach the Opened Lid

position (Figure 12). The lid will be installed when the lid is seated and in the horizontal

position (Figure 13).

PREPARING YOUR PRESSURE COOKER .

1. To open the lid, hold the Handle (1) and turn it in a clockwise direction until you reach the

Opened Lid position. Then pull upwards to vertical position (Figure 14 & 15).

2. Remove the inner pot (8) and place desired food and liquids into the pot. The amount of

water and food should not exceed 4/5 of the height of the inner Pot (Figure 16.) For food

that will expand in water, the level should not exceed 3/5 of the Inner Pot (Figure 17). The

minimum level for cooking would be 1/5 of the Inner Pot (Figure 18).

• When cooking rice, the maximum amount of rice

allowed for this 8 quart pressure cooker is 12 cups

of uncooked rice.

• Normally one cup of rice requires one cup of water.

This may vary according to taste.

3. Be certain the inner receptacle, where the Electronic

Heater is located, is clean before inserting the inner pot.

Place the inner pot into the pressure cooker and adjust the pot left and right to ensure

optimal contact between the Inner Pot and the Electronic Heater. (Figure 19)

•

During the process of installing the lid, please ensure that the height between the Lid and

the upper edge of the cooker is approximately 10cm. This is to ensure smooth movement

when turning and installing the lid.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Elite EPC-807 Platinum Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info