Bedienungsanleitung Enduro AS101 (Seite 44 von 48) (Deutsch, Englisch, Holländisch, Französisch)

722072

Zoom out

Zoom in

Vorherige Seite

1/48

Nächste Seite

ENDURO

autoSteady 37

Ref: AS101-UM-TKI-0114-Rev. A

Press for at least three seconds the “AUTO DOWN” button (Fig. 10J) with two hands at the same time. The blue

LED (Fig. 10K) will blink during these three seconds and every second there will be a beep. This is warning you

that the system will be activated.

After these three seconds the auto function will start and the corner steadies will automatically act. The blue

LED (Fig. 10K) on the remote control will illuminate continuously. Now you can release the “AUTO DOWN”

button.

The corner steady will act as following:

• first the two back corner steadies (Fig. 8B and Fig. 8D) lower

• then the two front corner steadies (Fig. 8A and Fig. 8C) lower

• than the back corner steadies (Fig. 8B and Fig. 8D) lower again

• finally the two front corner steadies (Fig. 8A and Fig. 8C) lower again

After activating the “AUTO DOWN” function, before the corner steadies lower, there maybe have a delay about

3 seconds. If one or more corner steadies are not at the complete draw back position, these corner steady will

be draw back for about 3 seconds first.

When the AUTO function process is finished, there will be a beep.

Since the autoSteady system is not equipped with an automatic levelling system, it can happen that the

caravan is not completely levelled out anymore. This can be caused by the use of a flexible jockey-wheel, or a

different spreading of the weight of your caravan or a different friction in the corner steady.

If needed, you can adjust every corner steady individually and slightly level out your caravan again.

The single corner steady function is used to adjust the height of single corner steady a little.

Do not try to jack the caravan by this function, this could completely damage your caravan

chassis or floor.

Different caravan chassis or floors have different situation for jack-up force. Using the

single corner steady function button have the possibility to completely damage your caravan

chassis or floor. The stop setup on the single corner steady function is used to protect the

motor and control unit, it cannot protect your caravan chassis or floor all the time (this due

to the various caravan models).

In general we recommend to use only the “AUTO” function.

After operation, deactivate the autoSteady system by moving the slide switch (Fig. 10A) to “Off”-O on the

remote control. The LED (Fig. 10H) on the remote control will turn off. Store the remote control in a safe place

(out of reach of children or other unauthorized people).

Turn off the battery power isolation switch (24).

When you want to draw back all the corner steady, you act as following:

Before starting the operation of the system, the handbrake must be secured and the jockey

wheel must be tightly fixed and tough the ground.

Turn on the battery power isolation switch (24).

Activate the autoSteady system by moving the slide switch to “On”-I on the remote control (Fig. 10A). The

green LED (Fig. 10H) will illuminate and you will hear a short beep. The system is ready for use.

First check if the slide switch (Fig. 10O) is in “autoSteady” mode (Fig. 10Q).

Press for at least three seconds the “AUTO UP” button (Fig. 10I) with two hands at the same time. The blue LED

(Fig. 10K) will blink during these three seconds and every second there will be a beep. This is warning you that

the system will be activated.

After these three seconds the auto function will start and the corner steadies will automatically act. The blue

LED (Fig. 10K) on the remote control will illuminate continuously. Now you can release the “AUTO UP” button.

The corner steady will act as following:

• first the two front corner steadies (Fig. 8A and Fig. 8C) draw back completely

• than the two back corner steadies (Fig. 8B and Fig. 8D) draw back completely

When the AUTO function process is finished, there will be a beep.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Enduro AS101 Seite 44

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info