601365

Enduro EM405 Seite 40

40
Zoom out
Zoom in
Vorherige Seite
1/60
Nächste Seite
ENDURO
®
EM405 S 34
Ref: EM405 S-UM-TKI-0115-Rev.A.
Put the plastic caps back on the motor housing.
As soon as the battery is charged again, or the problem is solved, the motor powered rollers automatically work
again.
OPERATION - REMOTE CONTROL HANDSET
The remote control handset (5) is powered by one PP3 9Volt battery, and is activated by moving the slide
switch to “On”-I (Fig. 5A). Once activated the green LED (Fig. 5H) will illuminate and the directional controls
can now be used.
Fig. 5
A. Slide switch (“Off” –O and “On”-I)
B. Caravan forwards (both wheels rotate in forwards direction)
C. Caravan reverse (both wheels rotate in reverse direction)
D. Caravan left forwards (right wheel rotates in forwards direction)
E. Caravan right forwards (left wheel rotates in forwards direction)
F. Caravan left reverse (right wheel rotates in reverse direction)
G. Caravan right reverse (left wheel rotates in reverse direction)
H. Green LED: reflects status of the remote control and caravan manoeuvring system
I. Two handed service for automatic engaging of the motor powered rollers to the tyre
J. Two handed service for automatic disengaging of the motor powered rollers from the tyre
K. Blue LED: reflects status of the automatic engaging system
L. Red overload LED: Amp overload protection is activated. Wait about 60 seconds and try again
M. Blue 9V battery LED: The internal 9V battery of handset is near empty and needs to be replaced
N. Blue battery voltage LED: Caravan battery voltage too low or too high
When you drive straight forwards or reverse (press button B or C), it is also possible to adjust the direction by
additional pressing button D or E (when driving forwards) or button F or G (when driving reverse).
In addition, the ‘right forward’ (E) and ‘left reverse’ (F) buttons or ‘left forward’ (D) and ‘right reverse’ (G)
buttons may be pressed at the same time to turn the caravan around on its own axis without moving forward or
backward (this function just can work under the “single-axle function”).
When you switch within 2 seconds from forward driving to reverse driving (and the other way around), a small
delay of 1 second will appear to protect the electronics and the motors.
The slide switch (Fig. 5A) also acts as an “Emergency stop”.
The automatic engaging system:
To activate the automatic engaging system of the motor powered rollers on the tyre, press the two buttons for
engaging (Fig. 5I) or disengaging (Fig. 5J) for at least three seconds. The blue LED (Fig. 5K) will blink fast
during these three seconds and every second there will be a beep. This warns you that the system will be
activated!
Engaging:
After these three seconds the motor powered rollers will be pressed against the tyre, and the blue
LED will illuminate constant. Now you can release the two buttons. When the motor powered rollers are pressed
on the tyre strongly enough you hear a short beep, the blue LED will switch off and the system is ready to use.
Disengaging:
after these three seconds the motor powered rollers will be released from the tyre, and the blue
LED will illuminate constant. Now you can release the two buttons. When the motor powered rollers are
completely disengaged you hear a short beep, the blue LED will switch off and is the system ready for transport.
The remote hand set switches off:
After 3 minutes, if no button is pressed: After 2 minutes the buzzer will beep for 5 times with a repetition
after 3 minutes. Than the system switches in the “stand-by” modes.
After 6 minutes, if one of the movement buttons is permanently held down: After 5 minutes the buzzer will
beep for 5 times with a repetition after 6 minutes. Than the system switches in the “stand-by” modes.
The green LED goes off and the remote control handset is in the “stand-by” modes which means that there
always will be used some current which causes the battery to go down. So always make sure the remote
control handset is turned off by the slide switch.
To reactivate the remote control, move slide switch to “Off” –O and then back to “On”-I after approximately 1
second.
Error messages via the remote control handset:
Error messages of the EN
DURO
®
EM405 will be communicated via the remote control handset by the green LED
(Fig. 5H), the error message LED’s (Fig. 5L, 5M & 5N) and a buzzer signal:
Green LED (Fig. 5H) off, no buzzer: remote control handset is turned off and also system is not activated
Green LED (Fig. 5H) continue on, no buzzer: remote control handset is turned on and system is activated
and ready to use.
… 40 …

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln
1

Forum

enduro-em405

Suche zurücksetzen

  • Rollen rücken nicht ein noch aus, blaue Kontrolleuchte reagiert nicht Eingereicht am 31-10-2022 17:02

    Antworten Frage melden

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Enduro EM405 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info