660386
6
Zoom out
Zoom in
Vorherige Seite
1/15
Nächste Seite
• 6 •
10. CONTROL PANEL
LED Indicators (All Models)
CHECK (red) LED lit: Indicates that the battery is not properly connected to the charger.
CHECK (red) LED ashing: Indicates that the charger is in abort mode.
CHARGING (yellow) LED lit: Indicates that the charger has detected a battery and
is charging it.
CHARGED (green) LED lit: Indicates that the battery is fully charged and the
charger is in maintain mode.
NOTE: See the Operating Instructions section for a complete description of the
charger modes.
Display Button (Models OMAX-12A-1B, OMAX-25A-1B)
Press this button to set the digital display to show one of the following.
Battery % – The display shows an estimate of the percent of charge of the battery
connected to the charger battery clamps.
Voltage – The display shows the voltage at the battery clamps in DC volts.
Display Button (Models OMAX-50A-1B, OMAX-40AS-3B, OMAX-50AS-3B)
Press this button to set the digital display to show one of the following.
Percent: The display shows an estimate of the percent of charge of the battery
connected to the charger battery clamps.
Volts: The display shows the voltage at the battery clamps in DC volts.
Amps: The display shows charge current provided by the charger in DC amps.
Charge Button (Models OMAX-6A-1B, OMAX-12A-1B, OMAX-25A-1B)
Press this button to set the charger to one of the following settings.
On: Indicates the charger is in charge mode.
Off: Indicates the charger is in test mode.
Output Button (Model OMAX-50A-1B)
Press this button to set the charger to one of the following settings.
On: Indicates the charger is in charge mode.
Off: Indicates the charger is in test mode.
Bank Button (Models OMAX-40AS-3B, OMAX-50AS-3B)
Press this button to set the charger to one of the following settings for each bank.
Charge: Indicates that bank is in charge mode.
Test: Indicates that bank is in test mode.
11. OPERATING INSTRUCTIONS
This battery charger must be properly assembled in accordance with the
assembly instructions before it is used.
Charging
1. Make sure that you have an Odyssey
®
battery.
2. Ensure that all of the charger components are in place and in good working
condition, for example, the plastic boots on the battery clips.
3. Connect the battery following the precautions listed in sections 6 and 7.
4. Connect the AC power following the precautions listed in section 8. Make sure to
place the charger on a dry, non-ammable surface like metal or concrete.
5. Select the appropriate settings for your battery.
6. To disconnect, reverse the procedure.
NOTE: Do not connect one OMAX-40AS-3B or OMAX-50AS-3B sequencing charger
to two or more batteries connected in a series. If the positive terminal of one battery is
connected to the negative terminal of another battery, then they are connected in a series
and must not be connected to the same OMAX-40AS-3B or OMAX-50AS-3B charger.
6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Enersys ODYSSEY Ultimizer Omax Batteries wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info