Bedienungsanleitung Enersys ODYSSEY Ultimizer Omax Batteries (Seite 7 von 15) (Englisch)

660386

Zoom out

Zoom in

Vorherige Seite

1/15

Nächste Seite

• 7 •

Permanent Ring Connectors (Model OMAX-6A-1B)

The ring connectors permanently attach to the battery, providing easy access to quickly

charge your battery. This application is appopriate for motorcycles, lawn tractors, ATVs

and snowmobiles.

1. To permanently attach to a battery, loosen and remove each nut from the bolt at the

battery terminal.

2. Connect the red POSITIVE connector ring to the POSITIVE battery terminal.

3. Connect the black NEGATIVE connector ring to the NEGATIVE battery terminal.

4. Replace and tighten the nuts to secure.

5. Connect the cable to the end of the charger output cord. Take care to keep the wires

and plug away from metal and moving parts.

6. Plug the charger power cord into a 120V AC electrical wall outlet. Make sure to place the

charger on a dry, non-ammable surface, like metal or concrete.

12. CHARGER OPERATION

The Ultimizer™ charger is custom designed to safely and quickly charge your Odyssey

battery using a three-step prole. It is very important that you not use this charger with

any battery other than Odyssey

as it can damage other lead acid batteries.

In the rst step, called the bulk phase, the battery is charged at up to the nominal charge

rate (6, 12, 25, 40 or 50 amps) until the voltage reaches about 14.7V. The charger then

switches to the second step, called the absorption phase.

In this step the charger continues to charge the battery at about 14.7V until either the

charge current drops to 100 milliamps or the charger has been in the absorption phase

for 4 hours, whichever occurs rst.

The charger then enters into the maintain mode phase at 13.5-13.8V. The battery can be

left connected to the charger indenitely.

The OMAX-40AS-3B and OMAX-50AS-3B chargers were designed to charge up to and

including three 12V batteries in sequence. When charging in sequence, only one of the

three banks is on at a time. Every few minutes, the charger will alternate which output

is on and which outputs are off. Each output will continue to turn on and off every few

minutes as long as more than one bank is set to charge. If only one bank is connected

to a battery and turned on, then it will charge continuously.

NOTE: Since each bank is on only half or one third of the time during charging, the

absorption phase could last 8 or 12 hours instead of only 4 hours.

Battery Connection Indicator

If the charger does not detect a properly connected battery, the CHECK LED will light.

Charging will not begin while the CHECK LED is on.

Aborted Charge (Model OMAX-6A-1B)

If charging cannot be completed normally, charging will abort. When charging aborts,

the charger’s output is shut off and the CHECK LED will blink. In that state, the charger

ignores all buttons. To reset after an aborted charge, unplug the charger from the AC

outlet, wait a few moments and plug it back in.

Aborted Charge (Models OMAX-12A-1B, OMAX-25A-1B)

If charging cannot be completed normally, charging will abort. When charging aborts,

the charger’s output is shut off and the CHECK LED will blink and the digital display

will show 18.8 and blink on and off (at opposite times). In that state, the charger

ignores all buttons. To reset after an aborted charge, unplug the charger from the AC

outlet, wait a few moments and plug it back in.

Aborted Charge (Models OMAX-50A-1B)

If charging cannot be completed normally, charging will abort. When charging aborts, the

charger’s output is shut off, the CHECK LED will blink and the digital display will show

8.8.8 and blink on and off (at opposite times). In that state, the charger ignores all buttons.

To reset after an aborted charge, unplug the charger from the AC outlet, wait a few

moments and plug it back in.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Enersys ODYSSEY Ultimizer Omax Batteries Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info