620000
17
Zoom out
Zoom in
Vorherige Seite
1/346
Nächste Seite
~33~
charger cradle.
Adjusting Handset Receiver (Earpiece) Voice Volume
1. Voice volume can only be adjusted during a call.
2.
There are 6 levels of volume selections. Use
or
key to adjust
3. The new setting remains effective for all future calls
until changed.
Adjusting Handset Speakerphone Voice Volume
1. Voice volume can only be adjusted during a call (in
speakerphone mode).
2.
There are 6 levels of volume selections. Use
or
key to adjust
3. The new setting remains effective for all future calls
until changed.
Placing a Call On Hold
1.
When a call is in progress, it can be put on hold by
pressing the
key.
2.
To return to the conversation, press UNHOLD (Left)
soft key
Notes:
1. The call being placed on hold can be “un-hold” by the handset
that puts it on hold. But if the handset press key to go back
standby, then other handsets can press or to pick
this held call (If press on base, it can also pick up this held
~34~
call).
2. Handset LCD displays a call is being on hold. An alert tone
(double beep) every 30 seconds will remind the handset that a
call is being on hold.
3. If the operation (e.g., call transfer) after putting a call on-hold
fails, the held call may be dropped.
Mute
1.
After a link is established, you can press MUTE (Left)
soft key to mute the handset microphone.
2.
When mute is active, the other end will not hear your
voice, but still can speak to you.
3.
To leave the mute state, press UNMUTE (Left) soft key. Mute is effective
only for the current call.
Do Not Disturb (Silent Ring)
1.
Enter the key sequence MENU-3-1, then select “Off”.
Press SELECT (Left) soft key to confirm your choice.
This will turn off the ringer until it is turn on again from
the menu.
Re: When setting the ringer “Off”, the standby screen
will show “Ringer off”.
2.
For temporary silencing the ringer when an incoming
call arrives, press SILENT (Left) soft key.
Key Guard
1.
To prevent accidental dialing, you can press MENU
(Right) soft key, then press1” to select KeyGuard
option. The handset keypad is locked. No key entry is
accepted.
2.
To unlock the keypad, press UNLOCK (Left) soft key,
17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Engenius EP802 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Engenius EP802

Engenius EP802 Installationsanweisung - Englisch - 2 seiten

Engenius EP802 Installationsanweisung - Holländisch - 2 seiten

Engenius EP802 Bedienungsanleitung - Holländisch - 31 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info