Bedienungsanleitung Etna a 361 k (Seite 45 von 50) (Holländisch)

336796

Zoom out

Zoom in

Vorherige Seite

1/50

Nächste Seite

General

In case of faults phone the service department.

See the guarantee certificate or consult the

internet site www.hps.nl.

If you notice a crack on the cooking

surface (no matter how little), switch

off the appliance immediately. Remove

the plug from the socket or set the switch of

the power supply cable (in the case of a fixed

connection) to zero or turn off the fuse switch(es)

in the meter cupboard.

Phone the service department.

This appliance should only be connected up by a

registered electrical installer!

The electrical connection must comply with

national and local regulations.

Damage caused by incorrect connection, incorrect

use or incorrect building in is not covered by the

guarantee.

FAULTS

MAINTENANCE

Table

If the appliance does not work properly, this does not always mean that it is defective. Try to deal with

the problem yourself first by checking the points mentioned below:

Fault Probable cause Solution

After the appliance has been electrified, text appears

in the displays.

Normal operation. NOTHING: see chapter “building in“ in the

installation part of this manual.

After the appliance has been switched on, the fuse in

the meter cupboard blows.

Appliance incorrectly connected. Check the electrical installation.

The fan keeps on running after the appliance has

been switched off.

The electronic circuits inside the hob are being

cooled.

This is normal.

The hob does not work and the lights are not on. The appliance has been connected incorrectly

or the mains voltage is not right.

Check the electrical installation (main fuse(s)

or the connection).

After the zone has been switched on, the displays

shows the symbol .

The pan is not suitable for induction cooking or

the diameter is less than

12 cm.

See chapter “Pans”.

While cooking, you hear a rattling noise in the base

of the pan.

The noise is due to the high power of the

cooking zone having an effect on the base of

the pan.

This is normal for some pans on higher

settings. It is harmless for the induction hob.

When you use the hob the first time, you notice that

it smells ‘new’.

This is caused by the appliance’s finish

heating up. It is perfectly normal.

The odour will disappear of its own accord as

a result of ventilation.

Failure code

A knob was operated too long or there is a

break in the cable.

Release the knob. Phone the service

organisation if the fault persists.

Failure code

E4, E5, E6 of E9

Defect of generator. Contact the service department.

Failure code E2 Appliance over heated. The appliance has been switched off because

of over heating. Let the appliance cool down

and start again on a lower setting.

Failure code E3

The pan is not suitable for induction cooking. See chapter “Pans”.

Failure code

The childproof lock is switched on. See “Childproof lock”, page 83.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Etna a 361 k Seite 45

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info