• Do not operate charging station if there is visible damage to the
unit or charging cable. Call manufacturer’s or reseller’s support
department for advice how to proceed.
• Do not put fingers into the charging connector.
• Do not operate the charging station with wet hands.
• The charging station manufacturer cannot be made liable for
damage or injury caused by improper handling, installation, or
use of the product.
• Any usage of the product not covered in this document is not
allowed and could cause injury or even death.
MAINTENANCE
• Charging station can be maintained and repaired by qualified
personnel only.
• Charging station’s power supply should always be switched off
during the maintenance and repair.
• Avoid hazardous risks. Only the manufacturer, an authorized
service technician, or technically qualified personnel may
replace damaged charging station or its components.
PROCEDURE IN CASE OF IRREGULARITY OR
INTERFERENCE AT OPERATION
In the event of irregularities or interference in the operation of the
device, immediately stop using the charging station and inform the
charging station operator of the situation by phone number located on
the housing or other place.
DESIGN CONSIDERATIONS
Special care has been put into selection of components and materials
and their compliance to requirements set in standards, technical
directives and rules of good practice.
The internal wiring was carefully designed, and the propriety of whole
assembly thoroughly evaluated. Basic design considerations include
voltage, insulating materials, time under voltage stress and degree of
pollution at the location. Creepage distances, clearance between circuits
and spacing to metal enclosures are important requirements for
insulation coordination. Thus, calculation and measurement of clearance
and creepage distances, in accordance with requirements, are one of the
significant parts in design of our products.
