31
packaging material has remained around the ‘head’ of the radiator. Ensure there
is a clear work space and keep flammable materials out of the area.
Check the device, the electrical cable and the plug for damage. Do not connect
the device to the mains if you notice any damage!
Do not connect the terrace radiator to the mains before it is fully installed!
This appliance can be secured to a wall or ceiling using a suspension brace or it
can be suspended from the ceiling using the suspension system included in the
pack.
The lowest point of the heater must
have a clearance of at least 180 cm
above the ground.
Ensure that around the appliance
there is at least 50 cm distance to
each wall and the ceiling, with the
exception of the wall or ceiling to
which the appliance is secured.
Ensure that at all times the
appliance’s projection is never
trained onto a wall or the ceiling
with a distance of less than 150 cm.
Your infrared projector is IP24 protected, i.e., protected against splashing water,
but not rainfall. Therefore select a place under cover outside.
Wall or ceiling assembly
The patio projector must be secured to a sturdy, flat wall/ceiling: one that is
strong enough to bear the load of the patio projector long-term. Secure using the
material included in the pack; do not use any other supports or attachments!
At the right distance (see picture), drill 4 holes (Ø 8mm) for the plugs and secure
one side of the wall/ceiling support bracket (2) using the plugs (1) and the large
screws (3) to the wall/ceiling. The wall bracket must hang completely horizontal
and level.
Unscrew the 2x3 screws from the round plates on the heater and remove the
plates with the suspension lines.
