59
When the number of the timer setting that you wish to change appears, press SET for a
little longer. You will hear a short beep and the selected setting has been deleted.
• If you wish to delete all timer settings, press the WEEK button and hold. Press and hold
the MOD and SET buttons at the same time, until you hear a beep. The screen will
show 88:88, indicating that all settings have been deleted.
Please Note: all timer settings can only be deleted with the buttons on the operating
panel, not with the remote control!
• If you wish to retain the timer details but do not want to use the timer for a while, push
and hold the WEEK button and then push and hold the MOD until TIME disappears
from the screen to indicate that the data will be retained but will not be active. By
pressing MOD again until TIME appears, you will reactivate the timer.
Screen protection: If the settings on a working heater are not adjusted for 2 minutes, the
LED display will go out but ON will stay on. It will light up again when you press a button. If
the heather is switched off using the ON/OFF button, the OFF screen will stay on.
Using with the remote control
The remote control (4) has the same 6 buttons as the operating panel (MOD = MODE) and
works in roughly the same way, but:
• You cannot use the remote control (under M-mode) to set the
capacity with the + or - buttons. Use the bar button for this
purpose.
• The remote control has an ECO button for an energy
efficient mode; the heater maintains the room at 16°C. The
screen shows EC. Deactivate by pressing ECO again. Nothing
else can be set under this setting. If the heater is working on
ECO setting and a timer setting becomes active, the heater will
start to work according to the timer setting. When the heat goes
off, the heater will not return to the ECO setting, but go off.
• The remote control also has an open-window detection; when you
choose this function, the heater will turn itself off when
the temperature in the room drops by 8 or more degrees
in 15 minutes. Turn the heater on again with the on/off
button. Press the symbol again to cancel the open-window
detection. The heater will begin to work in the pre-set function.
When the heater operates according to a set week programme
and you turn on the open-window detection, the heater will only
work during the set operating times of the week programme.
