57
External temperature sensor (5)
Because the temperature sensor is located on the heater, it does
not measure the external temperature very accurately. If you
want accurate measuring, connect the separate thermostat
(included in the delivery) by inserting the small plug into the
control panel and placing the sensor approx. 2 metres away from
the heater (see illustration). For this purpose, you should remove
the heater from the wall and subsequently, place it back. When
you have connected the separate thermostat, it automatically
takes over the thermostat operation.
Using the operating panel
The operating panel (2) has 6 buttons:
MOD / SET / WEEK / + / - / ON-OFF
• Press the ON/OFF button in order to switch the heater on. The display lights up and the
heater can be operated.
• Now, set the day and time. Press and hold SET until SET appears on the screen. The
numbers of the weekdays (line 4) will blink. Use the + and – buttons to find the right
day (1 – Monday, 2 = Tuesday, etc.) and confirm with SET. The hour will now blink. Use
the + and – buttons to set the right hour and confirm with SET. The minutes will now
blink. Use the + and – buttons to set the right minutes and confirm with SET. The day
and time are now set.
Please Note:
o The day and time settings will be lost if the heater is switched off using the main
switch or plug; these will be retained if the ON/OFF button is used.
o If you do not set a time and day, the heater will assume that it is day 1 and 00.00.
o The screen goes off automatically after 2 minutes and can be turned on again with
any button.
• Press MOD to set whether you wish to work with the M or P function.
• You can now turn On (1 sun) or turn Off (no sun) the heater using the + and – buttons
under M-function (remote control: the button with the bars). The thermostat cannot
be adjusted.
• Under the P-function, you can use the + and – buttons to set the desired temperature
for the heater, which it will then try to maintain. Once the desired temperature is
reached, the heater automatically turns off, and then back on again when it cools
down.
• Under the P-function, you can also set the weekly timer. Pressing WEEK, allows you to
set or check the weekly timer. Please note! To set the weekly timer, you must first
enter the day and time correctly.
