18
Wall mounting Golden 1800S
Drill four holes in the correct places for the
plugs and attach the wall bracket (G) to the
wall using the screws. The curved part of
the plate must be uppermost and the
‘keyhole’ must be located at the bottom of
the support. The wall bracket must be
perfectly vertical.
Attach the bracket (F) using the two small
screws on the patio heater, as shown.
Turn the hanging screw (H) into the
corresponding hole on the side of the patio
heater, until it protrudes a maximum of 5
mm (see diagram).
Hang the heater onto the wall support. The
bracket at the back of the heater unit must
fall into the curved part of the wall support; the hanging screw (H) must be
placed into the round part of the ‘keyhole’ on the wall support and then pushed
gently downwards until the patio heater is firmly affixed. Secure this with a bolt
(E) through both brackets (see diagram).
Check that the patio heater is attached firmly and fully horizontally before use.
Assembling the stand (Golden 1800S)
Place the bottom section of the stand (15, with
the fastening plate) on the base (14), in such a
way that the screw holes are aligned. Turn the
foot over and screw the lower section of the
stand from below with the plate and the locking
nut (see diagram). Turn the base the right way
up. Place the protective cover over the screw
connection.
Slide the adjustable, narrow section of the stand (18)
from below through the top section of the stand (17),
until it comes out again at the top (widening at the
base). Secure the adjustable section using the black
locking screw (21) that is located at the top of the top
section of the stand.
Push the centre section of the stand (16) into the lower
section (15), screw-hole to screw-hole. Secure with four
fixing screws. In the same way, secure the upper section
of the stand (17, with the adjustable part inside) over
the central section.
Screw the extra black coloured screw (supplied) into the
adjustable section of the stand so that it cannot, so that
it cannot slide into the upper section (to secure the
movable pipe).
