Description
A = Main switch B = Display C = Remote control
Location and Connection
Remove all packaging material and keep out of reach of children. After
removing packaging, check the appliance for damage or other signs that could
indicate a fault/defect/malfunction. In case of doubt, do not use the appliance,
but contact your vendor for inspection or replacement.
Select a suitable location for the device taking into account all the
aforementioned warnings in this manual.
The device has to be hung from a wall and therefore may not be used in a lying,
leaning, hanging or standing position!
The heater has to preferably be positioned at and permanently connected
to an electric socket. This connection may only be made by a qualified
electrician and, for that reason, is not described here.
In this booklet, for reasons of safety, use with a plug should be assumed;
when there is a permanent connection, any passages about the plug do not
apply.
Drill two holes in the wall at the required locations, to fit the plugs exactly:
make sure these holes are horizontal and 39.8 cm apart. Insert plugs and
screws into the holes. Allow the screws to stick out by 10 mm. Hook the heater
over the screws using the hanging eyes, then slide to the left and pull
downwards. The fixing material supplied is suitable for brick walls. Consult a
specialist, for instance at a DIY store, if your wall is built
of other material.
Check whether the heater is secured to the wall; if
necessary insert the screws a little further into the
plugs.
Attach the heater using the materials supplied. Place the
bracket on top of the heater (see picture) with the short
side against the wall. Mark the location of the hole on
the wall and remove the heater. Drill a hole at the
