Bedienungsanleitung Everdure Hub II (Seite 11 von 24) (Englisch)

798842

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

Assembly, Operation & Maintenance Instructions

Power supply interrupted Check the LED at the ignition switch is lighting when pressed. Check cord is connected & turned on. Check power is being supplied to

appliance (power outage or tripped circuit breaker). Check that retractable power cord has not been pulled out too far (it can interrupt

the internal power connection).

Poor type of solid fuel used Fuel may be wrong size (parts too large). Break up larger parts so they can ignite easier. Purchase a dierent type of charcoal and try. We

recommend using 100% natural lump charcoal in this appliance (see hestonbyeverdure.com.au/hestonbyeverdure.com.nz).

Solid fuel is damp Solid fuels can become damp over time, which retards ignition. Store in a dryer place & repurchase fresh solid fuel.

Solid fuel incorrectly distributed in charcoal

chamber

Follow the instructions on placing the solid fuel in the charcoal chamber. If charcoal has compacted down tight, remove some solid fuel

so air can ow freely through and assist in ignition. If too little fuel is used, the heat and ignition may not pass as fast between separate

pieces.

Timer or element not working Remove fuel and check LED on ignition switch is lighting up when pressed. Check for heat from the element (without fuel this should run

for 7 minutes before turning o) with a hand at a safe distance. If not running, contact your nearest Service Centre.

Internal components not aligned correctly Check element heat shield, support bracket and element are correctly positioned. Check charcoal chamber correctly allocated in lower

tabs. Check charcoal grid is correctly allocated in charcoal chamber.

Barbeque not cleaned Check ash has not collected inside the element bowl or heatshield, or blocked the charcoal grid

Weather conditions & ambient temperature Cold, windy and wet conditions will aect the ignition and combustion process. Move barbeque to a more suitable location.

TROUBLESHOOTING

Solid fuel is not igniting or taking longer than expected to ignite:

Rotisserie system not working:

Power supply interrupted Check the LED at the rotisserie switch is lighting when pressed. Check cord is connected & turned on. Check power is being supplied

to appliance (power outage or tripped circuit breaker). Check that retractable power cord has not been pulled out too far (it can

interrupt the internal power connection).

Rotisserie rod not seated in motor correctly Remove rod from poles and check motor socket is rotating. Place rod in motor and check handle end is correctly allocated in the slot of

the left hand pole.

Rotisserie overloaded Check rod rotates without food, and then with food. Remove some of the food from the rotisserie and try again

Rotisserie motor has jammed Motor or internal parts have seized. Contact your nearest Service Centre.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Everdure Hub II Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info