Bedienungsanleitung Exquisit GE 9106.1 T (Seite 5 von 58) (Deutsch, Englisch, Holländisch, Französisch, Italienisch)

717898

Zoom out

Zoom in

Vorherige Seite

1/58

Nächste Seite

NOZZLE CHANGEMENT OPERATION

1. Please use driver with special head to

remove and install nozzle as figure-7

2. Please remove nozzle (figure-8) from

burner with special nozzle driver and

install new nozzle (figure-9)

Figure - 7 Figure - 8 Figure - 9

Change the pipe for the connection gas: Following operation must be done

only by authorized service. If your oven is adjustment for use LPG, hose

nipple (3) is connected as shown in figure. During convert to NG from LPG,

hose nipple (3) must be dissembled by authorized service and the flexible

metal hose with mechanical connection from the gas network is connected to

the hose shown in figure number 1 that using a new seal (2) If your oven is

adjustment for use NG, there is no any nipple at the end of the hose. Every

change the pipe for the connection gas, ensure that leak proofing between on

the surface of the connection should be placed to the seal (2).This seal is

single-used.

1- Main gas pipe

2- Leak proofing sea

3- Hose nipple (for

LPG)

IMPORTANT WARNINGS

1. The cooker is supplied setup according to the conditions shown on the rating label which is stuck to the rear of

the appliance. From this sticker you can learn for which gas type (LPG or NG) this appliance is configured when

supplied.

2. Power supply voltage of your oven is 220-240V, 50-60 Hz for mono phase and 230V/400V, 50-60 Hz for 3

phases.

3. If the current rate of the fuse in your installation is less than 16 Ampere (for mono phase) 32 Ampere (for 3

phase), make a qualified electrician fit a 16 / 32 Ampere fuse.

4. Since the plug of your oven has earth system, ensure using socket with earth system. If it is used without earth

system, our firm is not responsible for any loss which may arise.

5. Keep the gas hose and electrical cable of your oven away from the hot areas; do not let them touch the appliance.

Keep them away from sharp sides and heated surfaces.

6. When the supply cable gets defective, get it replaced by conducting our service as soon as possible.

7. Before changing the oven lamp, disconnect the power plug from the wall socket.

8. Be sure that the cooker is configured correctly for local requirements (for example, the jets must be suitable for

local gas type and gas pressure)

9. Connect your oven to LPG cock in shortest way and without any leakage. Minimum 40 cm - Max. 125 cm

10. When making gas leakage check, never use any flame type like those of lighter, matches, cigarette fire or similar

ones.

11. Usage of your appliance creates moisture and heath in the room it is placed, make sure that your kitchen is

ventilated well.

12. Maintain the natural ventilation ducts properly.

13. When the oven is being used, the reachable parts may be hot, children should be kept off from hot surfaces and

the areas where charged with electricity.

14. When the oven is hot never touch the oven glass by hand or touch by means of a tool.

15. Before starting to use your appliance, keep curtain, tulle, paper or inflammable things away from your appliance.

Do not keep flammable materials inner side of or around the appliance.

16. You must use the safety sheath of control panel when the oven section is in grill mode.

17. Gas tapes are secured by locks. Do not turn before pressing the button.

18. Oven valve has safety cock. Flames are kept about 3-5 sec. If the oven burner can not flame, repeat this

procedure 5-6 times. If the problem persists, please contact with the nearest service.

19. Please place the tray to the lowest shelf and add 200 ml water when you cook something in chicken roast section.

20. Make sure that rear pulley section of the grill swelling is fixed on V-bed on the grill when you use the grill

swelling.

21. It is not suitable to operate both lower and upper burners simultaneously. The lower burner is designed for

cooking and upper burner is designed for frying.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Exquisit GE 9106.1 T Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info