Bedienungsanleitung Extraflame Isidora Idro H16 (Seite 23 von 40) (Englisch)

811756

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

23ENGLISH

OPERATION AND LOGIC

IGNITION

Once the points listed previously have been checked, press key 1 for three seconds to ignite the stove. 15 minutes are available for the ignition

phase. After ignition and having reached the control temperature, the stove interrupts the ignition phase and passes to STARTING.

PREPARATION

During the start-up phase, the stove stabilises combustion, increasing it progressively, to then start ventilation and pass on to WORK.

WORK

During the work phase, the stove reaches the set power set; see following item.

SET POWER

Set the operating power from 1 to 5 (using keys 2 and 3).

Power 1 = minimum level - Power 5 = maximum level.

SET H2O

Set the boiler temperature from 65 to 80°C (using keys 4 and 5).

PUMP OPERATION

The pump is activated when the internal water temperature reaches 60°C. Since the pump is always in operation above 60°C, it is advisable

to keep a heating area always open so that the product operates in a more homogeneous manner and in order to prevent stoppages due to

overtemperature. This area is usually called “safety area”

CLEANING

At preset intervals, the generator cleans the burn pot, turning the machine o.

When the cleaning phase is nished, the generator will re-start automatically and continue the working phase, returning to the selected

power level.

BLOW

During the working phase, the stove has an internal timer, which after a pre-set period of time cleans the burn pot.

This phase is shown on the display, it lowers the stove power level and increases the ue gas exhaust motor for a programmed period of time.

When the cleaning phase is nished, the stove will re-start automatically and continue the working phase, returning to the selected power

level.

MODULATION and HOFF

As the water temperature approaches the set point, the boiler starts to modulate automatically bringing itself to the minimum power. If the

temperature increases beyond the set point, it will automatically switch o indicating HOFF, and will automatically go back on when the

temperature drops below the set point.

SWITCHOFF

Press key 1 for three seconds.

Once this operation has been performed, the appliance automatically enters the switch-o phase, blocking the supply of pellets.

The ue gas exhaust motor and the hot air ow motor will remain on until the stove temperature has dropped below the default

parameters.

REIGNITION

The stove can only be re-ignited automatically or manually when the cooling cycle conditions and the preset timer have been satised.

IT IS PROHIBITED TO USE THE APPLIANCE WITHOUT THE PARTITION AND/

OR FLAME GUARD SEE FIGURE ON SIDE. REMOVAL WILL COMPROMISE THE

SAFETY OF THE PRODUCT AND RESULT IN THE IMMEDIATE NULLIFICATION OF

THE WARRANTY PERIOD. IN THE CASE OF WEAR OR DETERIORATION, REQUEST

AFTERSALES ASSISTANCE TO REPLACE THE PART REPLACEMENT IS NOT

COVERED BY THE WARRANTY AS THE COMPONENT IS SUBJECT TO WEAR.

PARTITION

FLAME GUARD

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Extraflame Isidora Idro H16 Seite 23

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Extraflame Isidora Idro H16

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info