Bedienungsanleitung FAAC 455 (Seite 23 von 28) (Englisch)

119529

Zoom out

Zoom in

Vorherige Seite

1/28

Nächste Seite

Page 23

January, 2004

412 Operator And

455 D Control Panel Installation Manual

THE 455 D CONTROL PANEL INSTALLATION INSTRUCTIONS

The procedure has ended and the gate is ready to

operate, using default slow down automatically set

by the control panel.

COMPLETE LEARNING

NOTES:

• If only one gate operator (1) is used, you

must go through the entire programming

procedure, as if you were programming a

gate operator (2). When the gate operator

(1) has finished opening, supply 5 open

commands until the gate operator begins

to close, and then resume normal

operations.

Close the gates, enter “B

ASIC PROGRAMMING”, select

the TIME LEARNING function and press the + push-

button for more than 3 seconds: the display begins

flashing and leaf 1 begins opening movement. The

following functions can be commanded by the OPEN

A command (by radio control or key push-button):

• When gate operator (1) reaches the

position that you want it to slow down, an

open command must be given to start the

slow down phase. When the gate operator

reaches its positive stop, the operator will

automatically shut off.

• An open command must be given to start

opening gate operator (2).

• When gate operator (2) reaches the

position that you want it to slow down, an

open command must be given to start the

slow down phase. When the gate operator

reaches its positive stop, the operator will

automatically shut off.

• An open command must be given to start

closing gate operator (2).

• When gate operator (2) reaches the position

that you want it to slow down, an open

command must be given to start the slow

down phase. When the gate operator reaches

its positive stop, the operator will

automatically shut off.

• An open command must be given to start

closing gate operator (1).

• When gate operator (1) reaches the position

that you want it to slow down, an open

command must be given to start the slow

down phase. When the gate operator reaches

its positive stop, the operator will

automatically shut off.

The display stops flashing and the gate is ready for

normal operation.

NOTES:

• The open command to slow down the gate

should be given before the gate reaches the

positive stop to prevent the gate from hitting

the stop at full speed. The positive stop could

be mistaken for an obstacle and then upon

hitting it, the gate(s) would automatically

reverse on contact.

AUTOMATED SYSTEM TEST

When you have finished programming, check if the

system is operating correctly.

Most important of all, check that the force is adequately

adjusted and that the safety devices are operating

correctly.

If pressure adjustments on hydraulic operators are not

set before programming. It may need to be

reprogrammed for desired results.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

FAAC 455 Seite 23

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von FAAC 455

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info