Bedienungsanleitung Fagor FIS 820 (Seite 13 von 44) (Deutsch, Englisch, Holländisch, Französisch, Portugiesisch, Spanisch)

456775

Zoom out

Zoom in

Vorherige Seite

1/44

Nächste Seite

Instructions for Use

Maintenance and Cleaning

Automatic Defrosting of the Refrigerator

The refrigerator requires no defrosting, since the ice at the rear

wall melts automatically. Ice, formed at the rear end during the

operation of the compressor, melts when the compressor is off,

and water drops slide downwards through the hole in the rear

wall o the condenser collecting receptacle, placed at the

bottom of the appliance.

Cleaning the Appliance

Disconnect the power supply before cleaning the appliance.

Do not use coarse or aggressive cleaning agents as you can

damage the surface. Be careful to remove any cleanser agent

remaining after cleaning.

• Clean the exterior with water and detergent.

Varnished surfaces are cleaned with soft cloth and an

alcohol based cleaning agent (for example glass cleaners).

You may also use alcohol (ethanol or isoprophylic alcohol).

The application of abrasive and specially aggressive

cleaners, such as the stainless steel cleaners, is not

appropriate for the cleaning of plastic and coated parts.

• Remove the detachable accesories in the interior of the

appliance and clean it with water and liquid detergent.

Plastic parts cannot be washed in washing machine.

• Wash the interior of the appliance with lukewarm water, in

which you added one or two spoonfuls of vinegar.

• The air openings in the bottom rail should be cleaned or

vacuumed periodically.

Cleaning of the condenser

Dust from the condenser should be vacuumed in the

following manner:

− push the finger through the opening in the bottom rail and

release the fastener;

− pull the rail towards you and remove it;

− remove the bottom board of the kitchen cabinet;

− pull the condenser dish out;

− use the vacuum cleaner to clean the dust from the condenser;

− replace the condenser dish and the bottom rail in the opposite

order.

After cleaning, connect the appliance to power supply and reload it.

Periodical cleaning of the condenser

In order to optimize the operation of the appliance and save

energy, it is recommended to clean periodically the dust from

the condenser at the back of the appliance.

Disconnect the appliance from the mains prior the

commencement of cleaning!

• Empty the contents of the appliance.

• Remove the supporting panel from the bottom of the kitchen

cabinet.

• Remove the screws fixing the appliance to the kitchen worktop.

• Pull the appliance out and expose the condenser at the back of the

appliance.

• Unscrew the screws from the condenser bonnet and remove the

bonnet.

• Clean the dust and dirt from the condenser.

After cleaning return the appliance to its place, plug in the

mains power cord and fill with food.

Switch Off the Appliance When Not In Use

If you do not intend to use the appliance for a longer period, set

the thermostat knob to the STOP (0) position, disconnect the

power supply, take out the foods and defrost and clean the

appliance. Leave the door slightly open.

Trouble-Shooting Guide

During the service, you can come across some troubles that in

most cases result from improper handling of the appliance and

can easy be eliminated.

The Appliance Fails to Operate After Connecting to the

Mains Supply

• Check the supply in the outlet socket and make sure the

appliance is switched on (thermostat knob in operating

position).

Continuous Operation of the Cooling System

• The door was frequently opened or it was left opened for too

long.

• The door is not properly closed (the door may sag, the

gasket may be polluted or damaged).

• Perhaps you have overloaded the appliance with fresh

foods.

• Insufficient cooling of compressor and condenser.

Check the air circulation through the bottom rail openings

and if necessary clean or vacuum the dust from the

condenser. See Section Cleaning and Maintenance.

Ice Formation on the Inner Rear Wall

Until the water is drained through the hole in the rear and into

the receptacle at the bottom of the appliance, normal

automatic defrosting of the appliance is guaranteed.

In case the ice formation on the inner back wall is increased (3-

5 mm), ice should be manually defrosted.

Set the thermostat knob to STOP (0) position and leave the

door open. Never use electric devices for defrosting and do not

scrape the ice or frost layer with sharp objects.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Fagor FIS 820 Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info