Bedienungsanleitung Falcon 900 deluxe inox (Seite 24 von 32) (Englisch)

326872

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite

Pressure testing

The gas pressure can be measured at the pressure

test point on the gas connection block.

Connect the pressure gauge. Turn on and light one

of the hotplate burners.

For Natural Gas the pressure should be 20mbar.

For Propane the pressure should be 37mbar.

Electrical Connection

This appliance must be installed by a qualified

electrician to comply with the relevant regulations

and also the local electricity supply company

requirements.

WARNING: THIS APPLIANCE MUST BE EARTHED

Note

The cooker must be connected to the correct

electrical supply as stated on the voltage label on the

cooker, through a suitable cooker control unit

incorporating a double pole switch having a contact

separation of at least 3mm in all poles. This cooker

must not be connected to an ordinary domestic

power point.

The total electrical load of the appliance is

approximately 7.2kW. The cable size used should be

suitable for this load and comply with all local

requirements.

Access to the mains terminal is gained by removing

the electrical terminal cover box on the back panel.

Connect the mains cable to the correct terminals for

your electrical supply type.

Check that the links are correctly fitted and that the

terminal screws are tight. Secure the mains cable

using the cable clamp.

Current Operated Earth Leakage Breakers

Where the installation is protected by a 30-milliamp

sensitivity residual current device (RCD), the

combined use of your cooker and other domestic

appliances may occasionally cause nuisance

tripping. In these instances the cooker circuit may

need to be protected by fitting a 100mA device. This

work should be carried out by a qualified electrician.

Hotplate

Check each burner in turn. There is a flame safety

device that stops the flow of gas to the burner if the

flame goes out. There is also a spark ignition system

that works when the knob is pressed in.

For each burner, push in and turn the knob to the

large flame symbol ( ).

The igniter should spark and light the gas. Keep

holding the knob pressed in to let the gas through to

the burner for few seconds.

If, when you let go of the control knob, the burner

goes out, the safety device has not held in. Turn the

control to the off position and wait one minute, then

try again this time holding in the control knob for

slightly longer.

Grill

Open the grill compartment door. Turn on the grill

control and check that the grill heats up.

Oven check

Turn on the ovens and check that they start to heat

up. Turn off the ovens.

Fitting the plinth

Remove the 3 screws along the front bottom edge of

the cooker. Hold the plinth in place and refit the 3

screws.

Customer care

Please inform the user how to operate the cooker

and hand over these instructions.

Thank you.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Falcon 900 deluxe inox Seite 24

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Falcon 900 deluxe inox

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info