Bedienungsanleitung Falcon De Luxe 1000DF (Seite 12 von 56) (Englisch, Französisch)

500343

Zoom out

Zoom in

Vorherige Seite

1/56

Nächste Seite

English

using a similar cleaning material. This will also restore

the polished ﬁ nish.

The Fan Ovens

The ovens have panels which have been coated with a

special enamel that partly cleans itself.

This does not stop all marks on the lining, but helps to

reduce the amount of manual cleaning needed.

The panels work better above 200°C. If you do most

of your cooking below this temperature, occasionally

remove the shelf supports and wipe the panels with a lint

free cloth and hot soapy water. The panels should then

be dried and the oven heated at 200°C for about one

hour. This will ensure the panels are working effectively.

This does not stop all marks on the lining, but helps to

reduce the amount of manual cleaning needed.

Don’t use steel wool (or any other materials that will

scratch the surface). Don’t use oven cleaning pads.

Troubleshooting

Steam is coming from the oven

When cooking foods with a high water content (e.g.

oven chips) there may be some steam visible at the

rear grille. Take care when opening the oven door, as

there may be a momentary puff of steam when the oven

door is opened. Stand well back and allow any steam to

disperse.

The oven fan is noisy

The note of the oven fan may change as the oven heats

up - this is perfectly normal.

The knobs get hot when I use the

oven or the grill, can I avoid this?

Yes, this is caused by heat rising from the oven or the

grill, and heating them up. Don’t leave the oven door

open. Make sure that the grill pan is pushed fully in when

grilling.

If there is an installation problem

and I don’t get my original

installer to come back to fix it who

pays?

You do. Service organisations will charge for their call

outs if they are correcting work carried out by your

original installer. It’s in your interest to track down your

original installer.

Current Operated Earth Leakage

Breakers

Where the cooker installation is protected by a 30-

milliamp sensitivity residual current device (RCD),

the combined use of your cooker and other domestic

appliances may occasionally cause nuisance tripping.

In these instances the cooker circuit may need to be

protected by ﬁ tting 100mA device. This work should be

carried out by a qualiﬁ ed electrician.

Food is cooking too slowly, too

quickly, or burning

Cooking times may differ from your previous oven.

Individual tastes may require the temperature to be

altered either way, to get the results you want. Try

cooking at a higher temperature setting.

The oven is not cooking evenly

Do not use a tin or tray larger than 300mm x 240mm.

If you are cooking a large item, be prepared to turn it

round during cooking.

If two shelves are used, check that space has been left

for the heat to circulate. When a baking tray is put into

the oven, make sure it is placed centrally on the shelf.

Check that the door seal is not damaged and that the

door catch is adjusted so that the door is held ﬁ rmly

against the seal.

A dish of water when placed on the shelf should be the

same depth all over. (For example, if it is deeper at the

back, then the back of the cooker should be raised up or

the front lowered). If the cooker is not level arrange for

your supplier to level it for you.

Oven temperature getting hotter as

the cooker gets older

If turning the knob down has not worked or only worked

for a short time then you may need a new thermostat.

This should be ﬁ tted by a service person.

Grill not cooking properly

Are you using the pan and trivet supplied with the

cooker? Is the pan being used on the grill carriage, not

the ﬂ oor of the compartment? Is the grill tray pushed

fully back to the stop?

Hotplate ignition or hotplate

burners faulty

Is the power on?

Are the sparker (ignition electrode) or burner slots

blocked by debris?

Are the burner caps correctly located?

Hotplate burners will not light

If only one or all the hotplate burners will not

light, make sure that the parts have been replaced

correctly after wiping or removing for cleaning.

Check that there is not a problem with your gas

supply. You can do this by making sure that other

gas appliances you may have are working.

Do the burners spark when you push in the control

knob? If not, check the power is on.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Falcon De Luxe 1000DF Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info