Bedienungsanleitung Ferm AGM1084P (Seite 7 von 156) (Alle Sprachen)

762283

Zoom out

Zoom in

Vorherige Seite

1/156

Nächste Seite

mains-impedance Zmax <0.348 Ohm, such

disturbances are not expected. (In case of

need, you may contact your local supply

authority for further information.

Immediately switch off the machine when:

• Excessive sparking of the carbon brushes and

verticiliosis in the collector.

• Interruption of the mains plug, mains lead or

mains lead damage.

• Defect switch

• Smoke or stench of scorched isolation



When using electric machines always observe the

safety regulations applicable in your country to

reduce the risk of fire, electric shock and perso nal

injury. Read the following safety instructions and

also the enclosed safety instructions.

Always check that the power supply

corres ponds to the voltage on the rating

plate.

Your machine is double insulated;

therefore no earthwire is required.

Replacing cables or plugs

Immediately throw away old cables or plugs

when they have been replaced by new ones. It is

dangerous to insert the plug of a loose cable in the

wall outlet.

Using extension cables

Only use an approved extension cable suitable

for the power input of the machine. The minimum

conductor size is 1.5 mm2. When using a cable

reel always unwind the reel completely.



Prior to mounting an accessory always

unplug the tool.



Fig. 2

The handle is suitable for either left or right-

handed use.

• Install the handle in such way that the holes

match the screwholes on the machine.

• Tighten the handle with the bolts and hexagon

key.



Fig. 3

• Press the spindle lock (5)

• Screw and tighten the pad holder on the spindle

• Depress the spindle lock (5)

• Mount the polishing pad (4) onto the pad

holder (5).



Fig. 4

Polishing pad (3)

This is used for high lustre polishing and waxing.

Wool polishing pad (4)

This is used for a high gloss finish.



Always follow the safety instructions and

keep to the applicable regulations.

• Hold the machine away from the workpiece

when switch it on and off.

• Always first switch the machine off after use

before removing the plug from the socket.



Fig. 5

The speed of the disc can be controlled with the

rotary knob on top of the handle.

The higher the position, the higher the speed.

When using wax on the polishing pad do not start

at a high speed.



Fig. 6

• This machine is equipped with a safety switch.

• Start the machine by pressing the “lock off” (B)

button (to disengage the switch) and switch on

the machine (A).



Release the switch (A).

The polisher will continue to run after it is

turned off.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Ferm AGM1084P Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info