Bedienungsanleitung Ferm CDM1112S (Seite 9 von 152) (Alle Sprachen)

632674

Zoom out

Zoom in

Vorherige Seite

1/152

Nächste Seite

 

activating the machine´s on/off switch.

Adjusting the gears

Fig. F

Never switch gears when the motor is

running, this will damage your machine.

Never put switch in the middle between

both positions, this will damage your

machine.

The machine has 2 drill speeds, which can be





shows which position is chosen.

 

diameter or screw driving. The machine has

high power at a low speed.

 

diameter

Adjusting the direction of rotation

Fig. G

  in

order to drive screws or to use it for drilling.

  in

order to remove screws.

Switching the machine on and off

Fig. G



machine and adjusting rotation speed.

 

the machine, the further the switch is being

pushed, the faster the drill will turn.

 

machine.

 

middle position to lock the movement of the

on/off switch. It cannot be activated in this

position.

Only lay down the machine when it has

stopped running completely. Do not

place it on a dusty surface as particles of

dust could get into the mechanism.

Adjusting the torque

Fig. G

The machine has 20 different torque settings

and a special drill mode to set the power being

transmitted to the chuck.



screws can be driven to a predetermined depth,

which is ideal for repetitive work. The higher the

number, the more torque will be transmitted.

 

work material.

 

work materials and when removing screws.

 

low as possible when driving screws. Select

a higher setting if the motor slips before the

screw is fully tightened.

 



) by fully turning it

counterclockwise.

Ensure that the direction switch (9) is

always set to during drilling.

The machine is equipped with electronic

overload protection function. When the

machine gets overloaded it will shut

down automatically. When this happens,

please wait for a few seconds to let the

overload protection reset itself.

Work light (12)

Fig. A

The machine is equipped with a work light to

illuminate the work location.

 

switch is being pressed.

 

switch is released again.

Belt hook (13)

Fig. A

The machine is equipped with a belt hook for

hanging the machine to your belt during use.

Always switch the direction switch (9) to

middle position to avoid accidental

startup of the machine.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Ferm CDM1112S Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info