779769
16
Zoom out
Zoom in
Vorherige Seite
1/27
Nächste Seite
3. Close the water tap for the water inlet.
4. Push the trigger until the pressure in the washer has been released.
5. Lock the trigger by pushing downwards onto the safety lock 14 .
Adjusting the handle
The handle can be adjusted in two positions. The washer is supplied with a lowered
handle.
1. Press the button 8 for the height adjustment and pull the handle 1 upwards until
it locks into place. The washer can be used and easily moved in this position.
2. Press the button again to lower the handle and push the handle downwards
until it locks into place.
Using a self-suctioning washer
Alternatively, you can also supply the washer from an open reservoir (water butt,
industrial water tank).
Use a suction hose with a suitable suction basket to protect the pump from foreign
bodies. We recommend using a high-quality suction hose made of reinforced
material, the diameter of which should be at least 13 mm and the maximum length
3 m. You can achieve the best results by integrating a non-return valve and filter in
addition to the suction basket.
To connect the suction hose, please proceed as follows:
1. Place the washer in close proximity to the water source on a stable and level
surface. Observe the maximum recommended suction height of 0.5 m.
2. Fill the suction hose with water and allow all of the entrapped air to escape.
3. Connect the suction hose to the washer. Remove all attachments.
4. Switch on the washer and press the trigger 13 until the washer discharges a
steady stream of water. If this is not achieved within 2 to 3 minutes, switch the
washer off and check the suction hose for entrapped air.
5. Switch off the washer and connect the desired attachment.
6. Operate the washer as usual.
In addition, please refer to the user manual of the relevant accessory part.
Operation
16
16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Ferrex Q1W-SP07-2200A wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info