796189
24
Zoom out
Zoom in
Vorherige Seite
1/152
Nächste Seite
Possible causes Solution
Filter bag full. Insert a new filter bag
(see section 11.5).
Dirty main filter. Clean the main filter
(see section 11.4).
Change the main filter
(see section 11.6).
Suction hose is
blocked or kinked. Eliminate the block or
straighten the hose.
Value set on the
suction power ad
justment [1-14] is
too low.
Set the suction power
to a higher value (see
section 10.1).
Battery charge level
low. – Charge the battery
packs.
– Use new battery
packs.
Electronic monitor
ing malfunction. Have the fault rectified
by a Festool service
workshop.
Working with sand
ers. Activate the bypass
function (see sec
tion 10.2).
10.4 Temperature cut-out
To protect against overheating, the tempera
ture cut-out switches off the cordless mobile
dust extractor before it reaches the critical
temperature. The status display LED [1-15] in
dicates a fault.
LED lights up red Excessive temperature
Switch off the cordless mobile dust extrac
tor, let it cool down.
Switch the cordless mobile dust extractor
on again after approx. ten minutes.
10.5 SysDoc
WARNING
Risk of injury
Do not stand on the storage area of the
cordless mobile dust extractor.
CAUTION
Risk of injury
When transporting, ensure that the T-Loc
is closed.
A Systainer can be fastened to the storage area
of the hose holder [1-3] with the T-Loc
lock [1-4].
10.6 Applying the brake
Raise the front of the cordless mobile dust
extractor slightly.
Push down the brake [1-10] until it engages
into position.
Actuate the release button [1-11] to release
it.
11 Working
11.1 Extracting dry materials
CAUTION
Hazardous dust
Damage to the respiratory passage
Always use a filter bag!
Check that the main filter is undamaged
before extracting.
When extracting dust that exceeds the
limit value, only extract from one dust
source (power or compressed-air tool).
Observe the following when extracting dust
generated by operating power tools:
Ensure there is adequate ventilation! Observe
regional regulations!
Limit values: Exhaust air max. 50% of the fresh
air volume
Equation: Room volume VR x air renewal rate
LW
11.2 Extracting wet materials/liquids
Remove the filter bag!
Use a special wet filter.
The dust extraction stops automatically when
the maximum fill level is reached.
The bottom LED [1-15] lights up red.
Switch off the mobile dust extractor [1-12].
Open the locking clips [1-7] and remove the
top section of the machine.
Empty the dirt trap [1-9].
After wet extraction, allow the main filter to dry!
Dry the mobile dust extractor before extracting
dry dust.
English
24
24

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Festool CTLC MINI I wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info