778615
20
Zoom out
Zoom in
Vorherige Seite
1/111
Nächste Seite
10.1 Kickback stop
WARNING
Risk of injury
The kickback stop does not guarantee com
plete protection against a kickback.
Always concentrate on your work and refer
to the safety instructions and warnings.
The kickback stop is triggered if the tool
is jammed, causing the power tool to
rotate around the screw axis suddenly
and unexpectedly. The power tool switches off,
beeps once and the LED light flashes continu
ously.
After the kickback stop has been triggered:
Release the on/off switch [1-5].
Eliminate the cause of the jam.
Press the on/off switch again.
10.2 Bit store [1-14]
CAUTION
Risk of injury from metal cuttings in the bit
store.
Clean the bit store regularly and clear out
metal cuttings.
Magnetic, for storing bits and bit holders.
11 Warning signals
Warning signals occur and the power tool switches off in the following operating states:
Signal LED light Cause Action
Beeps once. - Battery pack empty/incom
patible. Charge/change the battery
pack.
Power tool overloaded. Reduce the load on the pow
er tool.
When pressing the on/off
switch: Power tool has over
heated.
Once it has cooled down, re
start the power tool.
Beeps once. Flashes continuously. Kickback stop triggered. See section 10.1.
Beeps twice. - Preset torque reached. -
Beeps continuously. - The power tool is faulty. Contact the manufacturer to
rectify the fault.
12 Service and maintenance
WARNING
Risk of injury, electric shock
Always remove the battery pack from the
power tool before performing any mainte
nance or service work.
All maintenance and repair work which re
quires the motor housing to be opened
should always be carried out by an author
ised service workshop.
Customer service and repairs must
only be carried out by the manufac
turer or service workshops. Find the
nearest address at:
www.festool.co.uk/service
Always use original Festool spare
parts. Order no. at:
www.festool.co.uk/service
EKAT
1
235
4
To ensure constant air circulation, always keep
the cooling air openings in the motor housing
clean and free of blockages.
Keep the contacts on the power tool, charger
and battery pack clean.
13 Environment
Do not dispose of the device in the
household waste! Recycle devices, ac
cessories and packaging. Observe appli
cable national regulations.
EU only: In accordance with the European Di
rective on waste electrical and electronic
English
20
20

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Festool TPC 18-4 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info