Bedienungsanleitung Florabest FGG 5.5 A1 - 3201 (Seite 33 von 44) (Italienisch, Portugiesisch, Spanisch)

539235

Zoom out

Zoom in

Vorherige Seite

1/44

Nächste Seite

MT GB

Clamp the grease pan (22a) into the holder. When grilling,

excess grease accumulates on the bottom of the grill and

runs into the grease pan.

17. Place the black painted lavastone grate (24) on the lower

holders in the pan. Distribute the lava stones (25) evenly

in a single layer on the lavastone grate. For best grilling

results the grate should be covered to approximately

70–80 %.

Place the grill rack (26) on the upper holders in the grill pan

(see Fig. 17).

18. Clamp the warming grate (27) into the holes on the lid and

in the grill pan as shown in Fig. 18.

Mounting the gas hose

Regarding Fig. 19:

• Depending on national regulations, there are two ways to

connect the gas hose (28) to the grill. First take the protective

cap off the gas connection (11) if present.

Method 1:

• Firmly screw one end of the gas hose (28) onto the gas con-

nection (11) (left-hand threading). Do not use an extra gasket!

Tighten the gas hose union nut securely using a size 17 span-

ner; at the same time hold the gas connection in place with

pliers or a second size 17 spanner.

Method 2:

• Run a hose clamp of the right size a few centimetres over

the loose end of the gas hose (28). Then slide this end onto

the gas connection (11) (wet the gas connection somewhat to

facilitate sliding onto the hose). Fix the connection with the

hose clamp.

• Connect the other end of the gas hose (28) with the pressure

regulator included (29).

Separate instruction manuals are included with the gas hose

(28) and the pressure regulator (29). Follow these instructions

very closely when you connect the pressure regulator (29) to the

gas hose and gas container (the figures may differ for the hose,

pressure regulator and gas container depending on the respec-

tive national standards).

Lay the hose so that it is not kinked or twisted.

Attaching the textile cover

• Attach the textile cover (32) to the two front support legs as

shown in Fig. 21.

Setting up the grill

Attention Risk of damage!

Any screwed connections may gradually loosen dur-

ing use and affect the stability of the grill.

– Before you use the unit, always check to make sure the

screws are secure. If applicable, tighten all screws again to

ensure that the grill is stable.

1. Before use, place the grill on a level, solid base located

outdoors.

2. Place the gas container next to or behind the grill and do not

in any case place it on the support under the grill.

3. Check the gas container and the connections for leaks (see

chapter “Checking for gas leaks”).

4. Check the grill burner for any blockages if you have not used

the barbecue for a prolonged period of time.

Connecting the gas container

You will need a conventional, full container propane or butane

gas to operate this grill.

Note: Depending on national standards, the figures may

differfor the hose, pressure regulator and gas contai-

ner. If necessary, replace the hose if this is required by

national regulations.

Danger Risk of fire/explosion/poisoning!

Leaking gas may form a highly explosive air/gas mix-

ture that could cause a fire or explosion and could

result in life-threatening injuries or death.

– Never connect the gas supply to the gas grill without a pres-

sure regulator that corresponds to the country-specific pres-

sure.

– Use only one hose between the gas bottle and the grill; hose

should not exceed the recommended length of 1.50 m.

– Make sure that the gas hose has been firmly mounted and that

the hose connection is always accessible along its entire length.

1. Turn both temperature controls to the position (Off).

2. Make sure that the gas container valve (30) of the gas con-

tainer is closed.

3. Screw the safety cap (if present) off of the container valve

threading.

4. Check whether the gasket of the container valve threading is

present and that it is in good condition. Do not use any extra

gaskets!

5. Screw the pressure regulator (29) onto the container valve

threading as described in the instruction manual, which is

enclosed with the pressure regulator.

6. Lay the gas hose so that it does not kink or twist.

7. Check all connections for gas leaks (see section “Checking

for gas leaks”).

Checking for gas leaks

1. Turn both temperature controls to the position (Off).

2. Open the container valve.

3. Rub all screw connections and the gas hose with soap wa-

ter. If bubbles form, a connection is loose or the gas hose is

cracked and may no longer be used.

Do not use the grill, but immediately close the container

valve on the gas container.

4. Check the screw connections and if applicable, tighten them

more. Then repeat the check.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Florabest FGG 5.5 A1 - 3201 Seite 33

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Florabest FGG 5.5 A1 - 3201

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info