Bedienungsanleitung FoodSaver V3800 series (Seite 8 von 10) (Englisch)

610562

Zoom out

Zoom in

Vorherige Seite

1/10

Nächste Seite

www.foodsaver.com 1-877-777-8042

Care and Cleaning

To Clean Appliance:

1. Press On/Off and unplug before cleaning.

2. Do not immerse in liquid.

3. Open appliance door (D), while holding the appliance

with two hands, press two Release Buttons (J) with

your thumbs, rotate appliance away from you, and

allow appliance to rest on the counter.

4. Check Lower Gasket (L) around Drip Tray (N) and

Upper Gasket (P) which surrounds the Upper Bag

Detection Tray (O) to make sure they are free from

food materials and the lower Foam Gasket is properly

inserted into gasket channel.

5. Avoid using abrasive products or materials to clean

any appliance components. These cleaners can

scratch the surface and damage the black foam

rubber pads.

6. Use a mild dishwashing soap and a warm, damp

cloth to wipe away food residue inside or around

components.

7. Dry thoroughly before reusing.

8. If your appliance features a Drip Tray, empty Drip Tray

after each use (See Fig. 7). Wash in warm soapy water

or place in top rack of dishwasher.

Antibacterial Drip Tray & Upper Bag Detection Tray

Empty Drip Tray after each use (See Fig. 7). Wash in warm

soapy water or place in top rack of dishwasher. The Food

Sensors in the Drip Tray (O) will not function correctly if

liquid is allowed to remain in Drip Tray.

This appliance has a Tray Full indicator

. When excess

liquid fills the Drip Tray, the unit will turn off and the

Tray Full Indicator light will activate. To resume normal

operation, open Appliance Door (D), press two release

buttons (K), rotate appliance away from you, and allow

appliance to rest on the counter. Remove the Drip Tray,

emptyliquid, clean Drip Tray and replace in housing.

When replacing drip tray, set the right end of the drip

tray into place, then firmly snap the left side down (See

Fig. 8). Appliance can be used without Drip Tray, however

the Adjustable Food Sensor setting

will not function

without the Drip Tray.

Clean Upper Bag Detection Tray after each use. The

Upper Bag Detection Tray (P) is removable for cleaning,

remove by lifting the tabs on each end. Do not pull on

the Upper Bag Detection Flags to remove the Upper

Bag Detection Tray. Clean Upper Bag Detection Tray by

washing in warm soapy water or placing in top rack of

dishwasher. Upper Bag Detection Tray MUST be inserted

to use the appliance. Without the Upper Bag Detection

Tray, your FoodSaver

Appliance will not detect bag

when inserted in the Vacuum Channel (E). After cleaning,

hold appliance with two hands and rotate upright until

the latches lock.

FoodSaver

Accessories

1. Wash all FoodSaver

accessories in warm water,

using a mild dishwashing soap. Do not immerse lids

in water.

2. Dry thoroughly before reusing.

3. FoodSaver

Canister bases (but not lids) are top rack

dishwasher safe. Canister lids should be wiped down

with a damp cloth.

4. FoodSaver

Canisters and FoodSaver

Lunch &

Leftover and Sandwich & Snack Containers should

not be used in the freezer.

5. FoodSaver

Canisters should not be used in the

microwave or freezer.

6. FoodSaver

Lunch & Leftover and Sandwich & Snack

Containers are microwave and dishwasher safe (top

rack only).

13 14

Troubleshooting

Nothing happens when I try to vacuum package:

1. Check power cord to see if it is firmly plugged into

electrical outlet.

2. Examine power cord for damage.

3. Check electrical outlet by plugging in another

appliance.

4. If your appliance has latches, make sure the lid is

closed and the latch is in the locked position. Refer to

your QuickStart Guide for instructions.

5. If your appliance has a mode switch, make sure it

is set to the correct mode. Refer to your QuickStart

Guide for instructions.

6. Make sure bag is placed correctly down inside the

Vacuum Channel.

7. Wait 20 minutes to allow appliance to cool off, and

then try using it again.

Note: The appliance will shut off automatically if it

becomes too hot.

To keep your appliance from overheating:

Wait at least 20 seconds for appliance to cool down

before you begin vacuum packaging another item.

Keep lid open before vacuum packaging.

Air is still in the bag:

1. Make sure open end of bag is resting entirely inside

Vacuum Channel. If edge of bag is beyond Vacuum

Channel, bag will not seal properly.

2. Examine bag for leaks. To see if your bag has a leak,

seal bag with air, submerge it into water and apply

pressure. Bubbles indicate a leak. Use a new bag if

bubbles appear.

3. If you are using a custom-sized FoodSaver

Bag,

check seal of bag. A wrinkle in the bag along the seal

may cause leakage and allow air to re-enter. Just cut

bag and reseal.

4. Do not attempt to make your own side seams for a

FoodSaver

Bag. The bags are manufactured with

special side seams, which are sealed all the way to

the outer edge. Making your own side seams may

cause leakage and allow air to re-enter.

5. Make sure Accessory Hose is not inserted into the

Accessory Port.

6. Check gasket around Drip Tray and upper gasket

under the lid to make sure it is free from food

materials and is properly inserted into gasket

channel.

Fig. 7

Remove For Cleaning

Firmly Snap in Place

Fig. 8

FoodSaver V3800 series Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von FoodSaver V3800 series

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info