Bedienungsanleitung Freerider Companion FR168-3A2 (Seite 18 von 40) (Englisch)

665066

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

DISMANTLING PROCEDURE

Drive your Companion close to the vehicle into which you

are about to load it. You may need some assistance to lift

the components once your machine is dismantled.

1. Switch off your scooter. First remove the seat by

releasing the ‘black’ locking lever. Rotate the seat 90˚

to the right or left, lift the seat upwards slightly

twisting. This will release it from its mounting tube

(Fig 1, page 6).

2. Lift the black battery cover positioned to the rear of

your foot mat (fig 22). This is located by four lugs top

and bottom which clip into the plastic body panels.

3. Battery Plugs: Disconnect the two

‘

black’ shrouded

battery plugs by pressing the side latch and gently

pulling apart. These plugs are polarised and can only be

fitted together one way. Do not force together when re-

assembling (Fig 23).

4. Carefully lift up each battery pack with the black strap

provided. Use two hands for this operation, one on the

strap and one to steady the battery (Fig 24).

Note: Make certain that the battery carry pack is fastened

tightly prior to lifting the battery. Place the batteries on a

firm and safe surface. Your batteries are sealed and cannot

spill if tipped over. Always carry the batteries upright.

Warning: Do not place metal objects over open battery

terminals. BEW

ARE of short circuits. Make certain the

terminals are covered by the red and black plastic protectors

at all times.

5. Lift the front wire basket from the mounting bracket on

the handlebar cover, you will note this mounts on three

clips (Fig 25).

6. Lower the handlebars by releasing the locking lever

(Fig 7, page 8). The handlebar will rest on the floor

mat. Note place a soft piece of material under the

painted console for protection.

7. Electric Plugs: Disconnect the 6 pin ‘white’ connector

(Fig 26, page 19) by squeezing the small latch and

carefully pulling apart. This connector is polarised and

can only be re-connected together one way. Note the

locating lugs on the connector, do not force these

connectors together when refitting.

8. Locking Mechanism : The front and rear chassis

components are locked into position with a spring loaded

pin (fig 27, page 19). The spring loaded pin locates into a

hole in the rear of the front chassis unit preventing the two

chassis components from lifting apart during driving. To

unlock the two chassis parts rotate the locking mechanism

knob in an anti-clockwise direction indicated by the “

loosen’ arrow. Turn the knob approximately four full turns

until you can lift it upwards against the spring pressure.

9. Lower the handlebars by releasing the handle bar lock

(see fig 7 page 8). with the handlebars positioned in the

straight ahead position, place the steering locking pin (fig 28,

page 19) through the front location hole. The handle bars

are now prevented from swinging during transportation.

Warning: You must never attempt to drive your Companion

Scooter with the steering pin fitted. Failure to observe this

warning will put you in a dangerous situation.

10.You are now ready to separate the two halves of your

Companion. Warning: Before you carry out this operation,

have you remembered to unfasten the electrical connectors?

Failure to observe this warning could result in unnecessary

damage.

FIG 25

FIG 22

FIG 23

FIG 24

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Freerider Companion FR168-3A2 Seite 18

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info