Bedienungsanleitung Frigidaire ES300 (Seite 7 von 24) (Englisch)

603128

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

About the Ceramic Glass Cooktop

The ceramic cooktop has radiant surface elements located below the surface of the glass. The design of the ceramic cooktop

outlines the area of the surface element underneath. Make sure the diameter of the pan matches the diameter of the element

outline on the cooktop. Heat is transferred up through the surface of the cooktop to the cookware. Only flat-bottomed cookware

should be used. The type and size of cookware, the number of surface elements in use and their settings, are all factors that

will affect the amount of heat that will spread to areas beyond the surface elements. The areas surrounding the elements may

become hot enough to cause burns.

Dual Radiant Surface Elements (some models)

The dual radiant surface element is made up of an inner and outer coil within the same

surface element. A variable control is used to operate the different coils. The smaller or

inner coil has a lower wattage and can be used to prepare smaller quantities of food in

smaller pans. The dual element can also combine both the inner and outer coils for a

combined higher wattage. The combined operation should be used to prepare larger

quantities of food in larger pans.

Element On and Hot Surface Indicator Lights

Your range is equipped with two different surface control lights that will glow on your range—

the Element On indicator light and a Hot Surface indicator light.

The Element On located on the control panel, will glow when any surface element is turned

on. A quick glance at this light after cooking is an easy check to be sure all surface controls

are turned off.

The Hot Surface indicator light, located on the control panel, will glow as the surface

cooking area heats up and will REMAIN ON until the glass cooktop has cooled to a

MODERATE level.

Before Setting Oven Controls

NOTE: Please read detailed instructions for ceramic glass cooktop cleaning in the Care & Cleaning and Before You Call

checklist sections of this Use & Care Manual.

NOTE: Radiant elements have a limiter that allows the element to cycle on and off, even at the HI setting. This helps to prevent

damage to the ceramic smooth top. Cycling at the HI setting is normal and can occur if the cookware is too small for the

radiant element or if the cookware bottom is not flat.

About the Radiant Surface

Elements

The element temperature rises gradually

and evenly. As the temperature rises, the

element will glow red. To maintain the

selected setting, the element will cycle on

and off. The heating element retains

enough heat to provide a uniform and

consistent heat during the off cycle. The

ceramic fixture thermally insulates the

heating element, concentrating heat in the

heating zone. For efficient cooking, turn

off the element several minutes before

cooking is complete. This will allow residual

heat to complete the cooking process.

Warming Zone

Control

(some models)

Single Radiant

Surface Control

(all models)

Single Radiant (some models)

or Dual Radiant Surface Control

(some models)

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Frigidaire ES300 Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info