Bedienungsanleitung Fujifilm Finepix 40I (Seite 53 von 58) (Englisch)

101074

Zoom out

Zoom in

Vorherige Seite

1/58

Nächste Seite

105104

I can’t use the flash to

take pictures.

The flash will not charge.

The playback image is

too dark even though I

used the flash.

The image is blurred.

I cannot format the

SmartMedia.

I cannot erase all the

frames.

• The Mode dial has been moved to another

setting.

• The flash is set to Suppressed Flash

mode (The flash is closed).

• You pressed the shutter button while the

flash was charging.

• No compatible SmartMedia is loaded.

• The camera is set to Suppressed Flash

mode.

• The camera is set to Macro Photography.

• The battery is exhausted.

• The subject is too far away.

• Your finger covering the flash.

• The lens is dirty.

• The lens is zoomed to telephoto in Macro

mode.

• The SmartMedia is write-protected.

• The frame is protected.

• Set the Mode dial to the correct setting.

• Set the flash to Auto, Red-Eye Reduction or

Forced Flash mode (Pop the flash unit up).

• Wait until charging is completed before

pressing the shutter button.

• Load a new SmartMedia, erase a frame,

or remove the write-protection.

• Set the flash to Auto, Red-Eye Reduction

or Forced Flash mode.

• Cancel Macro Photography.

• Load a new battery.

• Move closer to the subject.

• Hold the camera correctly.

• Clean the lens.

• Cancel Macro mode.

• Remove the write-protection.

(Peel off the write-protect sticker.)

• Remove the frame protection.

Cause RemedyProblem

Troubleshooting eIf you think the camera is faulty, check the following once more.

No power

Power cuts out during

operation.

Battery runs out quickly.

No photograph is taken

when the shutter button

is pressed.

• Load a new fully charged battery.

• Plug the adapter back in.

• Load a new fully charged battery.

• Wipe the battery terminals with a clean,

dry cloth before charging.

• Put the battery in your pocket or another

warm place to heat it and then load it into

the camera just before you take a picture.

• Wipe the battery terminals with a clean,

dry cloth before charging.

• Load a new fully charged battery.

• Use Ni-MH or Ni-Cd batteries.

• Load a SmartMedia.

• Load a new SmartMedia or erase a

frame.

• Remove the write-protection.

• Format the SmartMedia.

• Wipe the SmartMedia contact area with a

clean dry cloth.

• Load a new SmartMedia.

• Switch the camera on.

• Load a new fully charged battery.

Problem Cause Remedy

• The battery is exhausted.

• The AC power adapter plug has come out

of the power outlet.

• The battery is exhausted.

• The terminals are soiled.

• You are using the camera in extremely

cold conditions.

• The terminals are soiled.

• The battery is flat.

• You are using alkaline batteries.

• No SmartMedia is loaded.

• The SmartMedia is fully recorded.

• The SmartMedia is write-protected.

• The SmartMedia is not formatted.

• The SmartMedia contact area is soiled.

• The SmartMedia is damaged.

• The Auto Power Off function has switched

the camera off.

• The battery is exhausted.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Fujifilm Finepix 40I Seite 53

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info