Bedienungsanleitung Fujifilm Finepix S 7000 (Seite 13 von 61) (Englisch)

101579

Zoom out

Zoom in

Vorherige Seite

1/61

Nächste Seite

24 25

Using

the Camera

Pressing the Shutter button down halfway, the

camera emits a short double-beep and focuses on

your subject. At that point, the AF frame on the

screen becomes smaller and the camera sets the

shutter speed and aperture (The indicator lamp

(green) stops blinking and remains lit).

●

The image shown on the screen before taking the shot may

differ in its brightness, color, etc. from the image actually

recorded. If necessary, play back the recorded image to

check it (➡P.29).

●

If the camera does not emit a short double-beep and “{”

appears on the screen, the camera cannot focus.

●

Pressing the Shutter button down halfway, the image on the

screen freezes temporarily. However, this image is not the

recorded image.

●

If “{” appears on the screen (e.g. the shot is too dark for

the camera to focus), try standing about 2 m (6.6 ft.) from the

subject to take the picture.

Bebeep

２５０２５０Ｆ５．６

Click

Pressing the Shutter button down fully without

releasing it, the camera makes a clicking noise and

takes the picture. The camera then records the

photographed image.

●

There is a slight delay between the Shutter button being

pressed and the shot being taken. If necessary, playback the

shot to check the image.

●

Pressing the Shutter button down fully in one motion, the shot

is taken without the AF frame changing.

●

Taking the shot, the indicator lamp lights orange (shooting

disabled). The indicator lamp then changes to green to

indicate that the next picture can be taken.

●

The indicator lamp blinks orange while the flash is charging.

The monitor may go dark briefly. This is normal and does not

indicate a fault.

●

See P.111, 112 for information on the warning displays.

◆

Using the FZ ring to adjust the zoom

◆

When the Focusing mode is set to S-AF or C-AF, the

FZ ring can be used instead of the Zoom button to

change the zoom setting.

Turn the FZ ring clockwise to zoom in and

counterclockwise to zoom out. A “zoom bar” appears

on the screen during zooming.

telephotowide-

angle

FZ ring

TAKING PICTURES

(

AUTO MODE

)

STILL PHOTOGRAPHY MODE

To zoom in on your subject, press “T” (telephoto)

button. To widen the angle of your shot, press “W”

(wide-angle) button. At that same time, the “zoom

bar” appears on the screen.

h Optical zoom focal length (35 mm camera

equivalent)

Approx. 35 mm-210 mm

Max. zoom scale: 6×

ＡＵＴＯＡＵＴＯ

２５０２５０Ｆ５．６

３３３３

Zoom bar

●

Zooming pauses briefly when it changes between optical

zoom and digital zoom (➡P.28). Press the same Zoom button

again to switch Zoom modes.

Frame the shot so that the subject fills the entire AF

(Auto Focus) frame.

●

If the subject is not in the AF frame, use AF/AE lock to take

the picture (➡P.27).

Brace your elbows against your sides and hold the

camera with both hands. Position the thumb of your

right hand so that it is handy for using the zoom.

●

The image will be blurred if the camera moves when taking

the picture (camera shake). Use a tripod to avoid camera

shake, particularly for shots in dark locations when the flash

is set to Suppressed flash mode.

●

There may be some unevenness in the brightness at the

lower edge of the LCD monitor. This is normal and does not

indicate a fault. This does not affect the photographed image.

Take care to hold the camera so that your fingers

or the strap do not cover the lens, flash or flash

control sensor. If the lens, flash or flash control

sensor is obscured by your fingers or the camera

strap, you may not be able to obtain the correct

brightness (exposure) for your shot.

●

Check that the lens is clean. If it is dirty, clean the lens as

described on P.107.

ＡＵＴＯＡＵＴＯ

３３３３

◆

Support for a cable release

◆

●

Do not apply excessive force to a cable release that is

attached to the camera as this could damage the camera.

A mechanical cable release can be used with this

camera.

Camera shake can be prevented by using a tripod

(sold separately) and cable release (sold separately).

Compatible cable releases:

ISO 6053:1979-compliant cable releases

Release socket

AF frame

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Fujifilm Finepix S 7000 Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info