503756
6
Zoom out
Zoom in
Vorherige Seite
1/32
Nächste Seite
6 EN
Setting up
Unpacking
The stand of this unit is folded when you purchased. Place this
unit face-down on a flat surface covered with the soft cloth.
Bend the stand slowly to forward until it clicks.
If you want to fold the stand again, insert a thin rod into the
hole in the right side of the stand as illustrated, bend the stand
backward while you keep pushing the hole.
Before Connecting
Please refer to the instruction books of this unit, Stereo
System or other devices as necessary to make the best
connections.
The following guideline is an option for the best sound quality
available on this unit.
Digital audio connections provide the clearest sound.
Connect the unit’s DIGITAL AUDIO OUT (COAXIAL)
to your amplifier or receiver (for DVD features only).
WARNING!
Never make or change connections with the power
switched on.
Note on a scart cable (Output):
When you use the scart cable to connect this unit to an
additional device, both video and audio signals of TV can
be delivered. (The video and audio signals of DVD and
external devices cannot be delivered.)
Connecting
Connecting the Cable
1) Insert the RF cable plug into the Aerial input jack at
the back of this unit.
2) Plug this unit into an AC outlet.
3) The ON/OFF (standby) indicator on the front panel
lights on, then press STANDBY-ON on the control panel or
the remote control to turn the unit on.
PROG. (+/
-
or / ) can also be used to turn the unit
on.
Connecting Additional Devices
You can connect an additional device such as decoder, satellite
receiver, camcorder, etc. to the AV-IN1 scart jack.
The scart jack to be connected is usually marked “AV” or
“TV” on the decoder or satellite receiver.
You can also use the AUDIO/VIDEO input jacks.
Note: To receive the signals from an external source, select
an input mode “AV1” or “AV2” on this unit by
pressing SELECT on the control panel or
INPUT SELECT on the remote control.
If you are using the AV-IN1 scart jack, select “AV1”.
If you are using the AUDIO/VIDEO input jacks,
select “AV2”.
Do not bend from this side.
VHF/UHF
MIXER
RF cable
(not supplied)
UHF
VHF
Scart cable (not supplied)
L4670EA(EN).fm Page 6 Tuesday, May 15, 2007 5:36 PM
6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Funai LDD-B2006 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info