Bedienungsanleitung Futaba 6EXAP (Seite 8 von 24) (Englisch)

28983

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

Current model

memory name

Modulation

indicator

Transmitter

battery voltage

Current model

memory number

LCD display screen

When the transmitter is initially

initially

turned on, the model memory number

model memory number

model memory name

, modulation type

modulation type

and transmitter battery

transmitter battery

voltage

are displayed on the LCD screen. When prompted by the user,

the functions and settings stored in the memory can also be read on the

screen. The user accesses the different functions using the MODE and

SELECT keys and changes the values and settings using the DATA

INPUT lever. (This is called programming!)

Note:

Feel free to explore by scrolling through the programs and viewing the displays using the MODE and SELECT keys.

The MODE and SELECT keys only determine what will be displayed on the screen and will not change any of the

settings. Only when using the DATA INPUT lever will you be able to change any of the settings.

Note:

Charging your batteries with the included Futaba A/C battery charger is always safe. However, fast-charging with an

aftermarket charger is acceptable as long as you know how to properly operate the charger. NEVER

NEVER

charge at a rate

higher than 1,000 mAh (1 Amp). If not done correctly, fast-charging can damage the batteries.

called

“memory.” If, for example, only two flights are made each time you go flying, the batteries will not have “reached”

very far down into their full capacity. After doing this several times the batteries will

“remember” and eventually “think”

they can supply only enough power for two flights. After two flights the batteries may not provide enough power to

operate the system, thus causing a crash. To erase any potential memory, cycle the batteries by discharging, then

charging them with a commercial battery cycler, or leave the system on and exercise the servos by moving the

transmitter sticks until the servos are moving very slowly, indicating that the battery is discharged. Cycling should be done

every one to two months, even during the winter or periods of long storage. If using a cycler with a readout, note the

capacity after the batteries have been cycled. If there is a noticeable drop in capacity the batteries should be replaced.

LIQUID CHIP DISPLAY (LCD) & PROGRAMMING CONTROLS

To open

programming menu;

Press both keys

simultaneously and

hold for one second

MODE key - use to select desired

function while programming

Throttle-cut button -

To use the throttle-cut

function,

SELECT key - use to select items within

function to be set or changed in the screen

DATA INPUT lever - use this lever to input

numbers or settings

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Futaba 6EXAP Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info