29043
19
Zoom out
Zoom in
Vorherige Seite
1/60
Nächste Seite
ADJUSTABLE FUNCTION RATE
AFR is a servo endpoint limiting function, similar to ATV with three exception:
1. AFR limits only the Dual Rate OFF (High
Rate) servo travel. Trim throw and Dual Rate
ON (Low Rate) limits are unaffected (unless
AFR is reduced below the D/R ON limit).
2. AFR can be used with mixing functions to
adjust more than one channel simultaneously.
For example, let's assume that the Aileron
Differential mixing program is activated, and
that CH1 controls the right aileron and CH7
controls the left aileron. AFR can be used to
adjust the aileron control response because
the CH1 and CH7 servos will be affected
simultaneously (Ex: Reducing the left aileron
AFR will reduce the left hand servo (CH7) UP
throw and the right hand servo (CH1) DOWN
throw simultaneously.).
With ATV, the CH1 servo and CH7 servo
throws in the above example would have to be
adjusted separately.
3. AFR sub trimmers are available on the front
trimmer panel for Aileron and Elevator AFR.
These allow quicker field adjustments in con-
trol response without the necessity of going
through the usual programming steps. Adjust-
ments can even be made during flight (by an
assistant). Maximum adjustment available on
the sub trimmers is ±25% of the amount of
travel set on the AFR program screen.
Setting Method
1) The setting method
for AFR is the same as for
ATV (See page 16).
2) Select the EDIT screen and press the AFR pro-
gram key.
3) The percentage figures displayed on the
extreme left and right sides of the screen
(CH1 and CH2 only) show the total amount
of travel actually set (The amount set with the
program
keys
+
or
the
amount
set
with
the
AFR sub trimmers.)
4) When the sub trimmers are turned slowly, a
tone will sound at the exact neutral position.
With the sub trimmer in neutral, the total
travel will equal that set with the program
keys.
In the bar graph illustration below, the right
hand throw is reduced to 70% of normal throw
by AFR. Note that the Dual Rate ON (Low
Rate)
limit
and
Trim
throw
limits
remain
the
same on both sides (Compare with the ATV
illustration on page 16).
NOTE: Trim Limits and D/R Limits same in both directions.
[17]
19

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Futaba 9VAP wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info