Bedienungsanleitung Futaba FP5NLK (Seite 3 von 6) (Englisch)

30018

Zoom out

Zoom in

Vorherige Seite

1/6

Nächste Seite

Elevator dual rate switch

This switch turns the

elevator dual rate function on and

off. The lower position is dual rate OFF and the upper

position is dual rate ON.

Elevator dual rate trimmer

This trimmer sets the elevator deflection angle when the

elevator dual rate switch is in the ON position. It has the

same functions as aileron dual rate.

Power switch

The upper position is ON.

Level meter

This level meter indicates the transmitter battery voltage.

Neck strap bracket

Bracket for the neck strap (optional).

Antenna

Strong telescoping antenna.

Extend

its full length

when using the transmitter.

Handle

Use this bar to carry the transmitter.

Nonslip adjustable lever head

The length of the lever head can be adjusted to fit the

operator.

Adjust to the length of your hand.

in the arrow direction, and adjust the head to

the most comfortable length, then lock it by

turning it in the direction opposite the arrows.

Battery cover

Remove this cover

when switching the

servo reversing

switches.

and

Unlock lever heads

. by turning them

Lever head

Remove the

battery

cover, by

pulling it in

the arrow

direction while

pressing

downward.

Fig.

Servo reversing switches

Fig.

Using the servo reversing switches

• The left side of each switch is the normal position.

•The

servo

reversing

switches

reverse

the direction

opera-

tion of the servos.

Fig.

Elevator servo

reversing switch

Aileron servo

reversing switch

Throttle servo

reversing switch

Rudder servo

reversing switch

Landing

gear servo

reversing

switch.

NORM - Normal

REV - Reverse

After linkage is complete, inspect the servos. If the direction of

operation of the stick lever and the direction of operation of a

servo are opposite, switch the appropriate servo reversing switch.

Transmitter NiCad battery NT-8LP

Charging jack

Battery charge jack for built-in NiCad battery.

•CHARGING OF

TRANSMITTER

AND RECEIVER

NI-CAD BATTERIES:

Recharge the receiver and

transmitter NiCad

batteries

as shown in Fig. 7.

AC-117V

Battery

Charger

Type

FBC-8B(4)

Rx:

Notes:

1) First, connect to TX NiCad

and red lamp goes on.

Then connect to RX NiCad

after connecting, L, E, D,

changes color trom red to

greenish red (orange)

which indicates that

both TX and RX NiCads

are being charged.

3) In case of separate

charging

L, E, D, color will be:

RX NiCad - Green.

TX NiCad - Red.

•Connect the charging plug of the FBC-8B charge to the

transmitter charging jack, connect the 3P connector of the

FBC-8B to the receiver NiCad battery (NR-4J), and plug the

FBC-8B to a 117VAC outlet as shown in this figure.

•The

Receiver

battery

can

used

about 10 times at 10

minutes per flight between rechargings.

• Charge the batteries for about 15 hours. When the set is

not

in use for some time, repeat discharge and charge two

three times before use. (If the batteries

are not used for a

long time, their capacity will go down).

• FBC-8B charges transmitter and receiver NiCad batteries

independently or simultaneously.

The tension of the stick lever spring can be adjusted.

Fig.

Tx.

Charging

plug

Fig.

(NR-4J)

LED

When adjusting the aileron,

and elevator the inside

module is removed.

Use a small Phillips

screwdriver.

Elevator

Aileron

Rudder

• The tension of the

spring can be adjusted

by removing the trans-

mitter back cover and

turning the screw for

each stick. Set the

springs for the best

stick feel.

When these screws are

removed, the back cover

can be removed.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Futaba FP5NLK Seite 3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info