781824
37
Zoom out
Zoom in
Vorherige Seite
1/87
Nächste Seite
Original User Manual Generator FX-SG Series
36
compressors, circular saws, concrete
cutters, and other construction equipment.
If the generator is to supply two or more
loads, observe the following:
Connect and switch on loads one
after the other.
Switch on high-power consumers with
high current consumption or high
starting recent first, then the lower-
power consumers.
Never connect loads to the 230 V and
400 V sockets at the same time.
In this case, the amplitude shift would
immediately blow a fuse.
Connection
WARNING!
Never connect the generator to the
mains supply on your own.
WARNING!
Qualified, authorized electricians may
only carry out a cable connection to
the house mains. Improper
connection can cause fires and
damage the generator!
Observe the following sequence:
Start engine (generator) - manually via
cable pull with handle or electric
starter.
Connect electrical consumers,
observe the starting sequence.
Switch on AC fuse switch.
Switch off generator
Observe the following sequence:
Switch off AC fuse switch.
Switch the on/off switch of the
generator to the "0" (OFF) position.
Turn the fuel tap to the "Shut off"
position.
Maintenance and care
WARNING!
Before carrying out any maintenance,
repair, cleaning, or inspection work,
ensure that the engine is switched off
and all components have cooled
down. Unintentional starting is
prevented by removing the spark plug
connector from the engine.
WARNING!
In the interest of your safety, only
perform the maintenance work
described here yourself.
In particular engine maintenance and
repairs, all other work must be carried out
by qualified, authorized personnel.
Improperly performed work can lead to
equipment damage and, as a
consequence, to severe injuries.
Maintenance intervals
Before each start
Check engine oil level
Check air filter, visual inspection for
dirt
After 20 h during initial operation
Change engine oil
After 20 h or every 3
months (every 10 h if dust
is present)
Clean air filter
After 20 h or every 6 months
Change engine oil
Clean oil filter cup
Clean oil filter cup filter
Clean spark plug
After 20 h or every year
Check valve clearance, have adjusted
if necessary
In case of emergency, immediately turn on/off switch of power
directly to position "0" (OFF).
37

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Fuxtec FX-SG7500B wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info