781824
39
Zoom out
Zoom in
Vorherige Seite
1/87
Nächste Seite
Original User Manual Generator FX-SG Series
38
Unscrew the oil filter cup.
Blow out the oil filter cup thoroughly
with compressed air against the
direction of the arrow.
Place new rubber sealing ring on
sealing surface of oil filter cup and
screw oil filter cup back in.
Troubleshooting
The engine will not start.
Check whether the on/off switch or the
key switch (for generators with electric
starter) is in the operating position -
"ON" position.
Check the engine oil level. If the oil
level is too low, the engine cannot be
started.
Check if there is fuel in the fuel tank.
Disconnect the spark plug connector,
remove the spark plug with the spark
plug wrench and check its condition.
Use a wire brush to remove soot
particles from the spark plug and
electrodes.
Check the electrode gap and adjust
it to 0.7 to 0.8 mm if necessary.
The generator does not produce
any current.
Connect a hand lamp to the generator
to check.
Check that the AC fuse switch is in
the "ON" position.
CAUTION!
Observe:
If the generator still does not start 0or does
not generate power, contact your dealer or
an authorized service shop for further
troubleshooting.
Cleaning instructions
Neglecting cleaning measures may lead to
material damage and malfunctions.
Do not spray the power generator
with water.
Keep ventilation slots clean and free of
dust.
Use a soft cloth and a soft brush for
cleaning the exterior.
Clean the tank cover seals regularly
and replace them if necessary.
Storage
NOTE!
Always store the power generator in a
clean, dry, and frost-free place.
If the current collector is to be stored for a
more extended period, proceed as follows:
Shut off fuel tap and unscrew oil filter
cup counterclockwise, drain and blow
out clean.
Position a suitable drain container under
the drain, open the fuel tap, and drain
the fuel entirely into the box.
Replace a sealing ring (rubber) and
screw the oil filter cup back in
clockwise.
Loosen carburettor drain plug and drain
residual fuel from the carburettor into a
suitable container. Tighten carburettor
drain plug again.
Unscrew the oil filler cap, unscrew the
oil drain plug and completely drain oil
from the crankcase into a suitable
container.
Retighten the oil drain plug and fill it
with suitable engine oil up to the
dipstick's upper mark. Screw the oil
filler cap back into the oil filler neck.
Pull until resistance is felt.
Pull the starter rope in doses until
resistance is felt.
CAUTION!
Keep the power generator clean.
39

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Fuxtec FX-SG7500B wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info