Bedienungsanleitung Gaggia RI9301 Gaggia Baby (Seite 14 von 78) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch)

544803

Zoom out

Zoom in

Vorherige Seite

1/78

Nächste Seite

ENGLISH

• 12 •

NOTE: It may happen that the self-priming feature of the

pump fails to work temporarily due to an air lock.

In this case water does not ﬂ ow from brewing head (14), and

the following procedure should be followed:

a) Place a small frothing pitcher or mug under the steam

nozzle (8).

b) Turn the steam knob (7) counter-clockwise to open the

steam/hot water valve, and turn the steam switch (4)

and the hot water/brew (2) to “On” to activate the

pump.

c) Alter a few seconds, a steady stream of water will emerge

from the steam nozzle.Allow about one cup of water to

ﬁ ll the pitcher. Shut the steam/hot water valve and turn

hot water/brew switch and the steam switch (4) to

“Off”.

d) NOTE: The temperature ready-light (5) will automatically

ﬂ ash as the machine boiler heats.

After switching on the machine for the ﬁ rst coffee, wait 6

minutes until the machine has fully heated up, while for

all subsequent coffees the machine will be ready to use.

Another feature of the machine is the “no-drip system”,

eliminating most of dripping from brewing head (14). After

coffee brewing, however, a little dripping may occur due to

wet coffee grinds in the ﬁ lter-holder.

Using the machine for the ﬁ rst time or

after a period of inactivity

This simple operation ensures an optimum brewing and must

be performed:

- at ﬁ rst start-up;

- when the machine remains inactive for a long time (more

than 2 weeks).

NOTE: Dispensed water must be emptied into an adequate

drain. It is not suitable for food use. If the container ﬁ lls

up, stop dispensing water during the cycle and empty it

before resuming the operation.

A (Fig.02) - Rinse the tank and ﬁ ll it again with fresh

drinking water.

B (Fig.03) - Place a container under the steam wand

(Pannarello). Open the knob (7) slowly by turning it

clockwise. Press the hot water/brew button (2) and

steam button (4).

C Dispense the whole water tank from the steam/hot

water wand. To stop dispensing, press the hot water/

brew button (2) and the steam button (4) again. Then

close the knob (7) by turning it counter-clockwise.

D (Fig.02) - Fill the water tank with fresh drinking

water.

E Insert the ﬁ lter holder into the brew unit from the bottom

(14) and turn it from left to right until it locks into

place.

F Place a suitable container under the ﬁ lter holder.

G Press the brew button (2) and dispense all the water in

the water tank. Once the tank is empty, stop dispensing

by pressing the brew button again (2). At the end, empty

the container.

H Remove the ﬁ lter holder from the unit by turning it from

right to left and rinse it with fresh drinking water.

I The machine is now ready to be used.

For further information on how to dispense hot water, please

refer to sections "How to brew a good Espresso

Coffee" and "Making Hot Water".

Caution: Never operate pump without water

in machine as damage to the pump may occur.

Damage of pump run without water is not covered

by warranty.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Gaggia RI9301 Gaggia Baby Seite 14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info