Bedienungsanleitung Gardena AquaContour automatic - 8133 (Seite 14 von 70) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Schwedisch)

820996

Zoom out

Zoom in

Vorherige Seite

1/70

Nächste Seite

3: Erratic spray-range changes must be avoided.

The smaller the angle α, the greater the devia-

tion from the programmed contour is.

3.3 Install ground marker in ground

[ Fig. I2 ]:

The Large-Area Irrigation AquaContour auto-

matic is equipped with 2 ground markers and

two programs so it can be used in two differ-

entlocations, e.g in front of and behind the

house, or with very large areas. To ensure that

the locations selected can be pinpointed again,

the large-area irrigation has to be fixed on the

ground markers with removable spikes. The

2spikes provided are attached to the bottom

of the large-area irrigation. The ground marker

should always remain in the ground.

1. Select correct location for large-area irrigation

(see above).

2. Insert ground marker 7 into soil at this point

level with the ground.

4. OPERATION

4.1 Select watering sector [ Fig. O1 ]:

A watering sector from 25° to 360° can be

selected. To prevent areas being watered unin-

tentionally (e.g. house), the sector should first

be selected roughly (slightly too small).

4.1.1 Roughly select sector:

1. Close water supply.

2. Turn the nozzle head w by hand to the middle

of the watering sector (e. g. P4).

3. Roughly select watering sector: turn right sector

stop ß

R to right-hand side (e. g. P9) and left sec-

tor stop ß

L to left-hand side (e. g. P2).

Note: When the water supply is open, the

sector-stop is shifted during switching of the

turn direction to its end position.

4.1.2 Re-adjust sector:

1. Open water supply.

2. Watch watering sector and re-adjust the sec-

tor-stops ß

L and ß

R according to the sector limits

(P1 and P10) until the change in direction

DANGER!

Cardiac arrest!

This product makes an electromagnetic field

while it operates. This field may under some con-

ditions interfere with active or passive medical

implants. To decrease the risk of conditions that

can possibly injure or kill, we recommend per-

sons with medical implants to speak with their

physician and the medical implant manufacturer

before you operate the product.

DANGER!

Risk of suffocation!

Small parts can be easily swallowed. There is

also a risk that the polybag can suffocate tod-

dlers.

v Keep toddlers away when you assemble the

product.

2. FUNCTION

2.1 Control panel [ Fig. F1 ]:

The GARDENA Large-Area Irrigation

AquaContour automatic can be used to water

individual garden areas. Two programmed

areas can be stored. A jet of water slowly turns

in acircle to the end of the programmed area,

stops, and turns back again, altering the irri-

gation range depending on the ranges pro-

grammed. The control panel is used to pro-

gramme the irrigation contour points.

1Menu button: Choose between program-

ming mode (Set 1 or 2)

and operating mode

(Auto 1 or 2).

2„+“ button: Increases irrigation range.

3„−“ button: Decreases irrigation range.

4OK button: Stores the irrigation range

selected.

5Set LEDs: Indicate programming

mode 1 or 2.

6Auto LEDs: Indicate automatic operating

mode 1 or 2. LED 1 or 2

flashes every 10 seconds.

3. INITIAL OPERATION

3.1 Insert batteries:

The batteries are not included with initial purchase.

v To insert batteries see 6. MAINTENANCE

Replace batteries.

3.2 Select correct location for

Large-Area Irrigation

AquaContour automatic [ Fig. I1 ]:

3.2.1 Correct location:

A Circle water distribution: With circle water

distribution the large-area irrigation should be

positioned as centrally as possible in the water-

ing area to ensure that the irrigation width is

not greatly affected by external influences such

as wind.

B Sector water distribution: With sector water

distribution the large-area irrigation should be

positioned right at the edge of the watering area

(e.g. at the corner of the house).

The large-area irrigation must be positioned

at apoint in the watering sector from which

it ispossible to water the entire garden area

required. The maximum range is 9 m (with 2 bar

flow pressure at the irrigation unit).

3.2.2 Incorrect location:

1: No obstacles (e.g. walls, trees, etc.) should

be located in the watering sector. It must be

pos sible to access every contour point of

the areas to be watered in a straight line. With

the maximum range the spray height can

reach approx. 5 m.

2: The minimum range is 2.5 m (at 2 bar). With

circle water distribution the large-area irrigation

must therefore be located 2.5 m from the edge

in all directions >. If this is not possible the

large-area irrigation should be positioned at the

edge and the watering area will be a circle

sector Y.

GAR_08133-20.960.11_2024-06-05.indb 14GAR_08133-20.960.11_2024-06-05.indb 14 05.06.24 11:2005.06.24 11:20

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Gardena AquaContour automatic - 8133 Seite 14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info