Bedienungsanleitung Gardena AquaContour automatic - 8133 (Seite 17 von 70) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Schwedisch)

820996

Zoom out

Zoom in

Vorherige Seite

1/70

Nächste Seite

6. MAINTENANCE

6.1 Replace batteries [ Fig. M1 ]:

If the Set LED 1 and Set LED 2 start flashing

every 8 seconds, the batteries have to be

replaced.

The programmes remain unchanged.

1. Turn the battery cover e on the bottom of the

Large-Area Irrigation AquaContour automatic

anticlockwise 1 and pull out carefully 2 (bayonet

coupling).

2. Remove battery holder r and insert 4 batteries

(1.5 V round cells type IEC LR14).

When doing so, ensure correct polarity + / −.

3. Re-insert battery holder r.

4. Fit battery cover e in reverse order.

6.1.1 Test battery:

The batteries must be tested after each

irrigation!

If no irrigation or programming is being made, the

sprinkler goes into “sleep mode” (the green Auto-

LED 6 does not light up and the red Set-LED

blinks every 8 seconds).

v During “sleep mode” (the green Auto LED 6

does not light up) press the two buttons “+”

button 2 and “−” button 3 for 4 seconds.

Both green Auto LEDs light up:

batteries have still enough capacity.

Both red Auto LEDs are blinking:

exchange batteries.

6.2 Clean dirt filter [ Fig. M2 ]:

1. Turn the dirt filter t anticlockwise 1 and pull out

carefully 2 (bayonet coupling).

2. Clean dirt filter t under clean running water.

3. Refit dirt filter t in reverse order.

6.3 Clean nozzles [ Fig. M3 / M4 ]:

If the watering pattern is no longer even, the

nozzles can be cleaned using the cleaning

needle provided. The cleaning needle is located

on the bottom of the housing.

1. Turn the cleaning needle z (e. g. with a coin)

anticlockwise through 180° and pull out carefully

(bayonet coupling).

2. Clean nozzles u with cleaning needle z.

3. Refit cleaning needle z in reverse order.

7. TROUBLESHOOTING

7.1 Troubleshooting table:

Problem Possible Cause Remedy

Irrigation width smaller than

on initial start-up Dirt filter soiled. v Clean dirt filter.

Tap not opened sufficiently. v Open tap further.

Water pressure too low. v Increase water pressure /

water supply.

Batteries are flat. v Replace batteries. If the bat-

teries are flat, the range is

reduced to the minimum level.

Irrigation range is programmed

incorrectly.

v Reprogramme irrigation range.

Watering pattern uneven Nozzles soiled. v Clean nozzles.

Nozzle head soiled. v Clean nozzle head.

Nozzle head damaged. v Contact GARDENA Service.

5. STORAGE

1. Remove batteries from the Large-Area Irrigation

AquaContour automatic.

The programmes remain unchanged.

2. Store the Large-Area Irrigation AquaContour

automatic in a dry place protected from frost.

Information about programming:

As soon as the first point is programmed, any

existing programme will be deleted. After pro-

gramming has been completed, no further

points can be deleted or added later on. If the

contour has not been set as required, repro-

gramming with more points will have to be car-

ried out. If no button is pressed for 60 seconds

during programming, programming will be auto-

matically ended and the contour stored.

4.3 Start / end watering [ Fig. F1 ]:

Before irrigation can be started, the Large-

Area Irrigation AquaContour automatic

must have been programmed.

1. Fit the Large-Area Irrigation AquaContour

automatic onto one of the two ground markers

with the 2 spikes (see 3. Initial Operation

lnstall ground marker in ground).

2. Select sector stops according to location

(see 4. OPERATION Select watering sector).

3. Press OK button 4.

The green Auto LED 6 lights up.

4. Select programme: Keep pressing Menu but-

ton1 until the required green Auto LED 6

(1 or 2) lights up.

The required programme 1 or 2 has been

selected.

4.3.1 Start watering:

v Fully open water supply.

Watering will start automatically and the contour

of the selected watering sector will be watered.

4.3.2 End watering:

v Close water supply.

Watering will end. The programme remains

unchanged.

GAR_08133-20.960.11_2024-06-05.indb 17GAR_08133-20.960.11_2024-06-05.indb 17 05.06.24 11:2005.06.24 11:20

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Gardena AquaContour automatic - 8133 Seite 17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info