Bedienungsanleitung Gardena R130Li Sileno (Seite 71 von 84) (Englisch)

672939

Zoom out

Zoom in

Vorherige Seite

1/84

Nächste Seite

English - 70

TROUBLESHOOTING

Trapped

The robotic lawnmower has got

caught in something.

Free the robotic lawnmower and rectify the

reason for it becoming trapped.

The robotic lawnmower is stuck

behind a number of obstacles.

Check if there are any obstacles which make

it hard for the robotic lawnmower to move on

from this location.

Outside working area

The boundary wire connections to

the charging station are crossed.

Check that the boundary wire is connected

correctly.

The boundary wire is too close to the

edge of the working area.

Check that the boundary wire has been laid

according to the instructions. See 3 Installation

on page 15.

The working area slopes too much

by the boundary loop.

The boundary wire is laid in the

wrong direction around an island.

Disturbances from metal objects

(fences, reinforcement steel) or

buried cables close by.

Try moving the boundary wire.

The robotic lawnmower nds it hard

to distinguish the signal from an

installation close by.

Place the robotic lawnmower in the charging

station and generate a new loop signal,

see 6.4 Security on page 47.

Wrong PIN code

Wrong PIN code has been entered.

Five attempts are permitted, and

the keypad is then blocked for ve

minutes.

Enter the correct PIN code. Contact

GARDENA Central Service if you forget the

PIN code. See MEMO on page 2.

No drive

The robotic lawnmower has got

caught in something.

Free the robotic lawnmower and rectify the

reason for the lack of drive. If it is due to wet

grass, wait until the lawn has dried before

using the robotic lawnmower.

The working area includes a steep

slope.

Maximum guaranteed slope is 35%. Steeper

slopes should be isolated. See 3.4 Installation

of the boundary wire on page 21.

The guide wire is not laid at an angle

on a slope.

If the guide wire is laid on a slope, it must be

laid at an angle across the slope. See 3.6

Installation of the guide wire on page 28.

Wheel motor

overloaded, right

The robotic lawnmower has got

caught in something.

Free the robotic lawnmower and rectify the

reason for the lack of drive. If it is due to wet

grass, wait until the lawn has dried before

using the robotic lawnmower.

Wheel motor

overloaded, left

Charging station

blocked

The contact between the charging

strips and contact strips may be poor

and the robotic lawnmower has made

a number of attempts to charge.

Put the robotic lawnmower in the charging

station and check that the charging strips

and contact strips make good contact.

An object is obstructing the robotic

lawnmower.

Remove the object.

Stuck in charging

station

There is an object in the way of the

robotic lawnmower preventing it from

leaving the charging station.

Upside down

The robotic lawnmower is leaning too

much or has turned over.

Turn the robotic lawnmower the right way up.

1157808,Gardena_R100Li-R130Li,GB_151217.indd 70 2016-01-12 09:17:09

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Gardena R130Li Sileno Seite 71

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Gardena R130Li Sileno

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info