687465
27
Zoom out
Zoom in
Vorherige Seite
1/56
Nächste Seite
Area 1, 2 or 3
How?
How far?
How often?
Disable
More
Lawn coverage
The factory settings allow the robotic lawnmower to
follow the guide wire 300 m in 20% of the times it leaves
the charging station. If the guide wire in reality is less
than 300 m the robotic lawnmower will follow it to the
point where the guide wire is connected to the boundary
wire.
3.16.1.1 Area 1, 2 or 3 > How?
The robotic lawnmower uses the Guide to reach Area 1,
2 or 3. If all areas will be used it is therefore important to
consider the optimal placement of the charging station.
The Guide needs to pass all areas but at the same time
not exceed maximum length of guide wire.
3.16.1.2 Area 1, 2 or 3 > How far?
Enter the distance in metres along the current wire from
the charging station to the remote area where the
robotic lawnmower begins mowing.
Use the right and left arrow keys to alternate between
the different options.
Tip! Use the
Test
function (
Area 1, 2 or 3 > More >
Test
) to determine how far it is to the remote area. The
distance, stated in metres, will be shown in the
lawnmower display when STOP has been pressed. See
How to measure the distance to a remote area on page
28
. The measured distance shown in the display can
be saved directly to the selected remote area. Any
current value will be overidden by the new measured
distance.
? m / ft.
3.16.1.3 Area 1, 2 or 3 > How often?
How often the robotic lawnmower must be steered to the
remote area is selected as a proportion of the total
number of times it leaves the charging station. At all
other times, the robotic lawnmower starts to mow at the
charging station.
Select the percentage that corresponds to the size of the
remote area relative to the total working area. If the
remote area is for instance half of the total working area,
50% must be selected. A lower figure must be specified
if the remote area is smaller. If more areas are used,
take into account that the total figure cannot exceed
100%.
Compare with the examples in
Yard layout examples on
page 33
.
Use the number keys to specify share as a percentage.
30%
20%
3.16.1.4 Area 1, 2 or 3 > Disable
Each area can be disabled and enabled without having
to reenter the settings. Select
Disable
and press OK.
3.16.1.5 Area 1, 2 or 3 > More > Test
Testing selected settings can be seen as a natural part
of the installation.
Using the
Test
function, the robotic lawnmower travels
the farthest distance from the guide wire allowed by the
selected corridor width.
3.16.1.6 Test: Area 1, 2 or 3
To test the selected settings:
1. Place the robotic lawnmower in the charging station.
2. Use the down and the right/left arrow keys to select
the area to be tested from the
Lawn coverage
overview
screen. Press OK.
3. Select
More
and press OK.
4. Select
Test
and press OK.
5. Press START and close the hatch.
6. The robotic lawnmower will now leave the charging
station and begin following the guide wire toward the
remote area. Check that the robotic lawnmower can
follow the guide wire all along the required distance.
7. The test is approved when the robotic lawnmower
can follow the guide wire to the required starting
point without any problem.
307 - 002 - 11.10.2017 Installation - 27
27

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Gardena SILENO plus R160 Li-LiC wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Gardena SILENO plus R160 Li-LiC

Gardena SILENO plus R160 Li-LiC Bedienungsanleitung - Deutsch - 56 seiten

Gardena SILENO plus R160 Li-LiC Bedienungsanleitung - Holländisch - 56 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info