Bedienungsanleitung Gardena SILENO plus R160 Li-LiC (Seite 28 von 56) (Englisch)

687465

Zoom out

Zoom in

Vorherige Seite

1/56

Nächste Seite

3.16.1.7 How to measure the distance to a remote area

1. Park the robotic lawnmower in the charging station.

2. In the

Area 1, 2 or 3

How far?

menu function, enter

a distance which beyond any doubt exceeds the real

figure. The maximum distance that can be entered is

500 metres.

3. Select

Area 1, 2 or 3

Test

and press OK.

4. Press START and close the hatch.

5. Press STOP at the required position. The distance is

now shown in the display. This figure can now be

saved in

Area 1, 2 or 3

How far?

3.16.1.8 Area 1, 2 or 3 > More > Reset

An individual area setting can be reset to the factory

setting using this function. To reset an area setting,

select

Area 1, 2 or 3

Reset

using the left right

arrow keys followed by OK.

3.16.2 Advanced

Under the

Advanced

heading, there are more settings

relating to the behaviour of the robotic lawnmower. The

settings in this menu are only required if additional

control of the lawnmower is needed e.g. in complex

gardens. The factory settings are selected in a way that

should suit most working areas.

Advanced

Corridor width

Exit angles

Reversing distance

Drive past wire

3.16.2.1 Corridor width

The corridor width is a measure of how far from the

guide wire/boundary wire the robotic lawnmower is

allowed to travel when it follows this to and from the

charging station. The area beside the wire which the

robotic lawnmower then uses is called the Corridor.

The aim of operating at varying distances from the wire

is to reduce the risk of tracks forming. Therefore it is

recommended to select the widest corridor possible

allowed by the size of the working area.

The robotic lawnmower adjusts the corridor width

according to the size of the working area when following

along a guide wire. The inbuilt automatic mechanism

allows the robotic lawnmower to vary the distance from

the wire depending on where in the working area it is

located. It automatically makes the corridor narrower in

narrow passages for instance.

The factory settings can be used for many working

areas, i.e. the robotic lawnmower itself can use the

inbuilt functions to operate in the widest possible

corridor. In more complex gardens e.g. where the guide

wire is placed close to obstacles which cannot be

isolated using the boundary loop, operational safety can

be improved by carrying out some of the manual

settings outlined below.

3.16.2.2 Corridor width > Guide

The guide corridor width is adjusted automatically. Only

in rare occasions manual settings need to be entered.

The guide corridor width can be set between

and

If value

is specified, the robotic lawnmower will

straddle the guide wire meaning it runs right over the

middle of the guide wire.

Use the arrow keys to specify the required value.

The factory setting is

3.16.2.3 Exit angles

Normally the robotic lawnmower leaves the charging

station in a direction within the 90°-270° exit sector. By

changing the exit angles, it makes it easier for the

robotic lawnmower to reach the largest working area if

the charging station is placed in a passage.

28 - Installation 307 - 002 - 11.10.2017

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Gardena SILENO plus R160 Li-LiC Seite 28

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Gardena SILENO plus R160 Li-LiC

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info