Bedienungsanleitung Gardenline BC35TS-2 (Seite 18 von 26) (Englisch)

724647

Zoom out

Zoom in

Vorherige Seite

1/26

Nächste Seite

31cc Brushcutter / Line Trimmer

AFTER SALES SUPPORT

e-mail: help@powertoolsupport.com

1800 909 909

MODEL: №. BC35TS-2 • 08/2018 • 49290

(toll free)

AFTER SALES SUPPORT

(toll free)

31cc Brushcutter / Line Trimmer

e-mail: help@powertoolsupport.com1800 909 909

MODEL: №. BC35TS-2 • 08/2018 • 49290

32 33

Feeding the line

The line trimmer has a bump feed mechanism which releases the line

without having to stop the engine.

1. To release additional line increase the speed of the motor to no less than

half speed, then, lightly tap the bump knob (34) on the ground while

operating the unit at high speed.

NOTE: Always keep the line fully extended for optimum cutting

performance. Line release becomes more dicult as the cutting line

becomes shorter. Cutting eciency also decreases as the line

becomes shorter.

The line will not extend if the speed of the spool is not operating at least

half speed. If the line does not extend, increase the speed to full speed

while tapping the bump knob on the ground. If the line still does not

extend, stop the motor and check the line inside the spool has not tangled

and also ensure there is sucient line in the spool.

2. Each time the head is bumped it releases approximately 2cm of line.

Release the line until it strikes the cut o knife (32). This may require

several taps.

NOTE: The cut o knife (32) on the clip-on line trimmer guard attachment

(33) will automatically cut o any excess line. For best results tap the head on

hard soil or bare ground. Never bump the spool head on concrete as it may

crack the spool housing. Make sure the cut o knife (32) protector has been

removed. It is recommended to replace the protector when the line trimmer

is not in use.

IMPORTANT. Do not hit stones (even small ones), piles of earth, and small

pieces of wood or anything else that could be hidden or poorly visible in

the grass. If you hit a large object by accident, or if you jam the cutting tool

due to overloading or having the cutter jammed with grass, you must stop

the engine.

NOTE: All protective devices of the machine as well as protective equip-

ment must be maintained in good operation condition during the period

of use.

NOTE: If the line is too short you may not be able to advance the line by

tapping it on the ground. If this is the case, stop the engine and manually

advance the line.

Fuelling

IMPORTANT: Fuel goes o after about 3-4 months. If you nd your unit does

not start, rst change the fuel in the tank with newly purchased fuel.

WARNING: Do not rell fuel tank while engine is running or is hot.

Move at least 10m away from the refuelling site before starting engine.

NOTE. Do not use fuel that contains ethanol. Use fresh unleaded fuel.

Do not smoke when refuelling or operating the product.

• Be careful not to admit dust, dirt, water or other foreign objects into

the fuel.

• Wipe o spilt fuel thoroughly before starting engine.

• Ensure you DO NOT fuel the unit in close

proximity to any open ames, lit cigarettes,

or hot objects.

1. Unscrew the fuel tank cap (5) (Fig AY) and pour

fresh unleaded fuel into the tank with the aid

of a funnel. (Fig. AZ)

NOTE: The fuel tank capacity is 650mL.

Be careful not to spill any mixture. If this

happens, wipe the spill with a clean rag.

2. Replace the fuel cap (5) taking care NOT to cross thread the cap on the

fuel tank (6). Tighten the cap rmly in a clockwise direction.

3. When starting the engine ensure it is at least 10m away from the area

where the fuel tank has been lled up in order to avoid any risk of re.

• Always use extreme care when handling fuel!

Fuel is highly ammable.

• Never attempt to fuel the product if the fuel

system components are damaged or are

leaking.

• Never attempt to refuel the engine while it is

running or still warm, allow it to cool before

fuelling.

AY.

AZ.

Operation of the Brushcutter / Line Trimmer

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Gardenline BC35TS-2 Seite 18

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info